Yup!
Type: Posts; User: EagleMark
Yup!
This is a go around the G2. No need to do this with G2.
That's why we started this site. Needed a place to put our stuff. Ideas and helping each other. Look at the FAQ top of the GM section for a ton of useful writeups and links. There's a thread in there...
But when you remove the old stuff from ECM board get a good solder sucker, about $10 at Radio shack.
Some guys say you have to scrape off clear coating on board but I have always just heated one...
I've never had any trouble with 60/40 rosin core.. is this just the wrong solder for ECMs?
I also use it for soldered wiring connections when I rework a stock harness...
What about a cable for datalog?
Using one of Moates Dip socket first would let the ZIF socket hang free where the wire is soldered on. Cleaner install for only $2. Should still fit under the hood!...
That's way cheaper than the adapter from Moates! I'll have to get a few of them.
Tried burning the old chips again this weekend. Got one out of three, still consistent!