Still no wheels! The powder coat shop got flooded with orders for mothers day and they are still back logged.:rolleye:

Got the plug out by drilling. In true fashion the plug did not free itself...

Drives me nuts to only work on this on Saturdays!
I didn't want to tie up the lift all week, so i downed her in the corner.

...

Good! I have no idea what 10k is, just lucked out by using the 88 truck!

BTW -Here was the pump install...

The parts/information I was needing was in your link, chapter 12 filled in the blank for me, thank you!


Done :thumbsup:


Perfect!


Seriously, where else can you find experts like...

Here is how it sits now with my buddy in it. (He has a 2000 Jeep TJ that is getting a 95 corvette engine this fall. His engine and trans came in last week.

I'm ready to get this truck finished!
...

A word about mating a 350 to a T98. I kept the T98 because its tough and I wanted to keep the PTO driven winch (PTO shaft-oily on the right, front drive shaft-green on the left). I bought an adapter...

Thank you for the tip! :thumbsup:



The local FD had one and I climbed all over it when I was a kid. It had a water tank in the bed and was set up to put out brush fires. It was so difficult to...

Cheap ebay headers
What size is that plug? Broke off an extension I ground down, didn,t budge, I think the water temp sencor goes in there!? I installed a cheap oil sending unit back by the end of...

Here's what I've got to work with:
http://i1278.photobucket.com/albums/y506/Maingear81/d2d76e408822b39d81bb3e8b815ede79_zps3b655a30.jpg

67 M715 5.89 gears 4 speed T98 divorced transfer case...

Thanks

I looked all over for an off the shelf ring, rather than cutting one out, and couldn't find one for that unit. Still have steel splinters in my hand from the tank's soft metal :/

Justin

Here is a shot of the unit tucked under the bed, between stringer. Ensure rubber padding is attached between tank and bed.

Fuel lines are aircraft 3/8 (AN6) tubing and russell metric to AN6...

http://i1278.photobucket.com/albums/y506/Maingear81/th_6d8dd50aed017c02cac51fb2c2f4f94a_zpse173d9b4.jpg

With the bends straightened out so the pump's pre-filter is 1/4" off the bottom, I double...

http://i1278.photobucket.com/albums/y506/Maingear81/th_4d053966358207c6c35e1a37973d4327_zps4a4108da.jpg

Here you can see the piece that was cut out, them carefully hammered flat. See where the...

I read where in tank pumps were superior to out of tank electric pumps. A little planning and work would save me some money (out of tank electric pumps can be expensive)

Don't kill yourself by...

Thank you
I recognize your icon from many excellent threads I have read. :thumbsup:

The project with my helper. He always there to hold my beer when I say, "Hey yaw, watch this!"
...

Research for my project drove me to your site. Thanks to everyone who has contributed and shared their knowledge!

My current project is a 1967 M715. It is a tractor that I can drive on the road,...