Search:

Type: Posts; User: ralmo94

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. I seen your other post, Have you disabled VATs?...

    I seen your other post,
    Have you disabled VATs?
    Is the file on your p59 a match for engine and transmission?
    Have to be careful if p59 was drive by wire, DBW pcm's from what I have read do not...
  2. Thread: 16197427

    by ralmo94
    Replies
    3
    Views
    102

    My 94 k1500 had a 6395 stock and runs $0D. I...

    My 94 k1500 had a 6395 stock and runs $0D. I don't believe there is any advantage of 7427 vs 6395?
  3. Replies
    30
    Views
    16,178

    Found another one that has a 2timer built in for...

    Found another one that has a 2timer built in for $36
    18697
    https://boostednw.com/honda-sst-chip-adapter-with-2-timer
  4. Replies
    30
    Views
    16,178

    Just found another site that developed a...

    Just found another site that developed a replacement.
    It's a little cheaper at $15 a chip
    https://www.burton-racing.com/collections/ecu/products/sst-chip
  5. Replies
    30
    Views
    16,178

    Was browsing the web and stumbled across a site...

    Was browsing the web and stumbled across a site that has sst chips.
    Says limit 10per customer.
    Kinda pricey at $20 a chip + shipping...
  6. I wish there was a like button for that comment....

    I wish there was a like button for that comment.
    I don't think you will find another, never been used,one anywhere.
    Cotton Picker thought me a lot. Good guy :rockon:
  7. Replies
    8
    Views
    194

    I would just set it to the stock values, and...

    I would just set it to the stock values, and adjust from there, IF NEEDED.
  8. Replies
    8
    Views
    194

    I found a Stock file on HPT Respository Here is...

    I found a Stock file on HPT Respository
    Here is the table and HP description

    [ECM] 12430 - Open Loop F/A vs. Coolant Temp vs. MAP: This table is used to determine the commanded AFR when in open...
  9. Replies
    8
    Views
    194

    -22, means it is taking 22 percent out, that is...

    -22, means it is taking 22 percent out, that is rich.



    There should be a table of commanded ratio per engine temp, and possibly a warm up multiplier?
    You don't want to change VE, you already...
  10. Replies
    8
    Views
    336

    OS 12606960 Are the Max Allowed Rotation...

    OS 12606960

    Are the Max Allowed Rotation Tables dependant on TAC combatability if set "less" than stock?

    Thank you for any information you share
  11. Replies
    8
    Views
    194

    Did you ever get a wideband o2? If you did, you...

    Did you ever get a wideband o2? If you did, you could tune the warm up enrichment
    If not, what are your O2 readings before it goes cl, pegged, or almost 0?
    Is it cl when it does this? Maybe...
  12. Replies
    30
    Views
    16,178

    No more 27sf512? Glad I just bought a couple

    No more 27sf512?
    Glad I just bought a couple
  13. The second table looks like the difference button...

    The second table looks like the difference button is pushed?
  14. Replies
    30
    Views
    1,367

    I don't have any oBd2 ADX's, I primarily use HP...

    I don't have any oBd2 ADX's, I primarily use HP tuners since I invested in there interface long ago. I wasn't aware there were any specific OS ADX's available?
    What interface are you using, could...
  15. Replies
    64
    Views
    60,470

    quite a bit of timing in that bin. Does super...

    quite a bit of timing in that bin. Does super Chips say to run premium fuel?
  16. Replies
    30
    Views
    1,367

    thank you for confirming what I always believed. ...

    thank you for confirming what I always believed.
    True or not I also believed that exhaust modification also alters it, air in air out.
    Although maybe not enough to worry about?
  17. Replies
    30
    Views
    1,367

    To log WBo2, you should connect the 0-5vlt analog...

    To log WBo2, you should connect the 0-5vlt analog signal to blue pin 55. This is egr position sensor .
    You need to have commanded egr to 0, disable egr codes, and zero out egr fuel reduction and...
  18. Replies
    8
    Views
    336

    I don't think I have any redundant tables defined...

    I don't think I have any redundant tables defined in HPT.
    I played with some of these settings on a trailblazer once, but it was before I knew there was a possibility of bricking something, and if...
  19. Replies
    30
    Views
    1,367

    It's a lot easier to dial the VE in, then turn...

    It's a lot easier to dial the VE in, then turn MAF back on any further corrections apply to MAF if you dialed VE in real close.
    You can also just drive so as to try and keep the engine in near...
  20. Replies
    8
    Views
    336

    For the max rotation allowed?

    For the max rotation allowed?
  21. Replies
    30
    Views
    1,367

    You failed the VE and are running MAF only? If...

    You failed the VE and are running MAF only? If so, what did you change to do it?

    Or did you mean to say you failed the MAF, so it will use the VE only?
  22. Replies
    8
    Views
    336

    ETC DBW Settiings?

    I was going to change the [ECM] 33010 - Throttle Max Rotation % vs. RPM: & [ECM] 33012 - Throttle Max Rotation % vs. Pedal: Tables to try and get little better economy on a 2004 5.3 Silverado, I...
  23. Replies
    118
    Views
    4,092

    30's is definitely not bad. What were you...

    30's is definitely not bad. What were you getting with Chuck's tune?
    You might need to mess with airflow idle settings, possibly warm up mixture
  24. Thank you for confirming it was helpful. Not to...

    Thank you for confirming it was helpful. Not to shabby mpg. Wish I had a suggestion for your cel
  25. Replies
    1
    Views
    163

    See my post here...

    See my post here
    http://www.gearhead-efi.com/Fuel-Injection/showthread.php?11377-hello-80-el-meano-ls-swap&p=96372#post96372
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4