ok I drove it today and datalogged it. I think this thing is lean all the way around. where would I start to add fuel across the board? I would think on a cold start warm up afr would want to stay...
Type: Posts; User: Mark1978
ok I drove it today and datalogged it. I think this thing is lean all the way around. where would I start to add fuel across the board? I would think on a cold start warm up afr would want to stay...
Dave check the open loop afr vs. temp vs vacuum table values, in the other bin vs this one. I just changed them in this bin. I'll burn the chip and try it in the morning. The original values seemed...
ok I set the injector flow rate to 58 and I am still way lean, also it hunts for idle. This was a cold start.
MYSTERY SOLVED! I'm an idiot. On the burner 2 it says "notch toward handle" so I've been installing the chips all the way to the top. While the lower part of the burner clearly says (in very small...
ok question- when I put a chip into the burner 2 and hit "erase chip" it says operation successful, but when I hit blank check it says chip is NOT blank. if I load a file and prog the chip, then hit...
ok I just removed the chip adapter and installed the memcal. BOOM- connected. So I must have something in my settings in tunerpro wonky. When I uninstalled and re-installed the program it picked up...
I’m using a Moates burner2
ok after many different approaches I need some help. In the first bin "dataworks" data logging works, in the second bin "no data" datalogging does not work. the first chip I burned one time. the...
Well I have to use a track pad on a laptop to slide the values. I tried clicking on the numbers to type a value but you have to slide the bar. Did you see any reason the datalog would not function?...
I think I messed up something with the burn process. Maybe I accidently changed a setting or something. The chip that I was using to datalog works fine. So I copied it to a buffer and then burned it...
OK now I have something weird going on. I tried changing the injector flow and it brought the fuel trim where it needed to be but raised the idle. Also since I burned that chip (separate than the one...
Dave, I am using an AEM 30-4110 with the 0-5v output wired direct into the ecm per the screenshot. I also downloaded the spreadsheet file you created and open office to open it. But I cannot open the...
ok here's the short version:
94 k2500
355 vortec flat top pistons
gm performance cam
bbc tbi red top injectors/ 97 vortec fuel pump
I am running $OD and have the wideband wired up
Now when I...