I have the HPT file itself. Can I use LSDroid to load it on my dummy ecm?
I tried it with LS Droid and found that the file wasn’t compatible.
Type: Posts; User: 57210
I have the HPT file itself. Can I use LSDroid to load it on my dummy ecm?
I tried it with LS Droid and found that the file wasn’t compatible.
Could I use LSDroid to load and then read it back?
Is there an easy way to change a HPT file to a BIN file?
Looking for the LQ9 VE tables. Are they much different from the LQ4 tables?
Is the VIN tied to a specific OS? Will my VIN work if I change the OS?
Did you ever find one?
I have a 2002 Escalade 6.0 AWD with OS 12209203. There isn't a XDF for this OS that I can find. Can I change the OS to something with a XDF file available without messing up the BCM stuff? Thanks for...
Rick I am wanting to be able to change some things on my 02 Escalade. I'll need a TunerPro XDF and I don't think there is one for the 12209203.
I've got a P01 from a 2002 Escalade. Is there a good substitute OS that has a XDF for it?
I have a 2K sender from JTR. Can I just splice into the A10 lead for the speedometer?
I have the EBL Flash-II
The speedometer needs 12v
Input 3K-100K per mile Hall effect sensor or magnetic sensor
Can I use the VSS signal for the SW electric speedometer? If so where do I tap into it?
I put an EBL in my 48 Willys wagon with a vortec 5.7 and a TBI. I spoke with you several time , trying to figure out why it was using so much gas. I finally decided to change the rear end ratio to a...
I am trying to get registered at Code 59 website, but have been unable to receive an activation code. Does anyone know if the site is still active?
Thanks for any info you might share.
The OS is 12212441
Does anyone have a good source to get terminals to redo the ECM connectors on a 16197427?
I was looking at the BIN with $42-1227747-V5.9.3 XDL and $42-1227747-V5.2 ADX in TP. I loaded up the 42 XDL and 42 ADX and got the same figures that you did.
Thanks for your input
I opened two stock bins and they ere the same. That's why I was looking to see what hey sholdbe set at.
I need to turn the EGR back on for emission testing. Three things that I'm not sure where they need to be set.
EGR Min TPS to allow EGR on mine is set at 80%
EGR On Low VAC Kpa ...
I went back and added VE2 figures to the VE1 table. After I zeroed out the VE2 table, I closed it and reopened it and all the RPMs had 5.08 for a correction factor.
I zeroed it again and came up...
Thanks for the info. I've read that thread, but I was trying to find out where these number in VE2 come from
How is this table populated? Someone said that there was a sticky by Rbob that explains the different tables.
Thanks for any info
I'm trying to set up a history table for my VE tuning. I've got
ARJT BIN
XDF $42-1227747-V5.9.3
ADX $42-1227747-V3T
When I get to the step to click on the Output Z, My browser box is empty....
I wanted to say Thanks for all the help with this. I finally found that the ECM I used for this was bad. I got another one and soldered it up this morning all the chips I burned seem to come up fine....