Thanks Mark. Everything in the distributor looks ok, nothing rotted. The multi meter is auto ranging to 20Mohms, can just set it to Ohm test and go. it does have resolutions listed in the manual for...
Type: Posts; User: conwaymuddy
Thanks Mark. Everything in the distributor looks ok, nothing rotted. The multi meter is auto ranging to 20Mohms, can just set it to Ohm test and go. it does have resolutions listed in the manual for...
Picked up a multi-meter today. Checked for continuity between the pick up coil and distributor, screen read O.L. measured the resistance of the pick up coil and best steady reading i could get was...
Thanks for the tip with tbe fusible link, ill have to check them when i clean the connections. First thing i did was check the fuses, of course it couldnt have been something simple. Im still...
The last time i poked around to check for spark and fuel the starter was still engaging and spinning the motor. Does the fusible link at the starter control anything other than the starter ( im not...
Forgot i had this posted here. Thanks for the replies. Havent had much chance to work on this with the below 0 temps. The motor isnt seized and you can hear the starter working as it should. Checked...
Tried to fire the car again today. First time the starter solenoid engaged then nothing. Battery connections were good but i disconnected the neg anyway. Hooked it back up had no power. Wiggled it a...
Camaro is giving me fits. Its an 89 RS 305 tbi 700r4 car. Havent ran it for a while so i figured id warm it up yesterday. Put the fully charged optima red top in and it would crank over but wouldnt...
I have figured out the wires going to the data link since they come from the pcm to the big black or clear plug. The stump of a harness is from a 93 gmc truck with 5.7 auto, new harness is from 94...
I had actually talked to a friend, he said on the trucks the v.s.s. buffer recalibrates the signal when you put the truck in 4low. Just what i was told. The 3 wires for the O2 are for running a...
Do my level best to explain what im working with here. These to plugs are on the harness going into the truck. The two wire red goes to a fuaible link the grey goes to the wiper motor plug. The big...
You have a good point. So far anything ive pulled has been wrapped and labelled. Im just trying to limit how much stuff is running around since the truck goes crashing through the woods and from time...
Still at the pink wires... can i just cut the pink wire that supplies power to the e-trans? Not running an e-trans in the truck. Also have a pink wire with a white tracer from the fuse block, was...
After looking at wiring diagrams and my other trucks i figured that stuff was A/C stuff and pulled it. I still dont know what the plug with the 2 yellows, white, and black wires is for. any thoughts...
After more tracing the black from the big plug goes to a common ground which goes to these two plugs.
http://i1243.photobucket.com/albums/gg546/ConwayMuddy/IMG_20130726_183913_606_zpse545e91b.jpg...
The pink wire comes from the firewall plug near where the steering column comes through. Chilton shows it coming from a 20A fuse to the transmission. The only wire coming out of the trans on the...
This is the face of said plug http://i1243.photobucket.com/albums/gg546/ConwayMuddy/IMG_20130726_144422_010_zps85758bc5.jpg
I think this plug is for the fuel pump relay though it has some wires...
Thanks. I labelled it vss when i first pulled it from the truck looking at a generic diagram for 88-98 c/k trucks. The chilton diagram has different wires for this year and engine/ trans, and the...
http://i1243.photobucket.com/albums/gg546/ConwayMuddy/IMG_20130726_123110_393_zpsa257bb21.jpg
http://i1243.photobucket.com/albums/gg546/ConwayMuddy/IMG_20130726_123135_515_zps038b7346.jpg...
Wheres my V.S.S.? chilton shows f2- red/black and f3 - dark blue/ white to v.s.s. I dont have those in this harness. What i believe is the plug for v.s.s. has purple/white , green/black twisted to a...
The only one im really unsure of is the small 3 wire. Im pretty sure its all a/c control. Ive got one plug from the dash connection that : have no idea what its for. Cant find it on any diagram...
[QUOTE=Shawn1989;25432]1st 2 connectors are pcm, the other ones and gray box, i have no idea about
http://i418.photobucket.com/albums/pp270/no_refuse/null_zps607e436f.jpg
I have all the same...
Thanks. I still have the wiring original to the tbi set up so i can always steal the plugs from that if they are different. Wasnt sure if the brake switch really did much other than the canister...
Try this again after the site logged me off and this disappeared.
I think these should be all the wires/ pins i need to run the engine
A5,a4,f11,b2 - distributor
E15,a16,a9 - injectors
A10,...
Th400 has a vacuum modulator to control shift points. Truck only sees park, neutral, reverse, and first. I think my driving style is why i blow up transmissions. Hopefully at some point ill get a...
Just how bad will an engine run without a vss? How hard is it to tune out? I run turbo 400 trans and there is no vss. I know i can put one in but i tend to go through a trans a year and dont want to...