Do a search on you tube and it kind of walks it through it. It works for Ed as you've read and I have same issues as you do. Ed is a great guy maybe he will do for you what he did for me. Send him...

Aw never mind read your post wrong....sockets not chips....yesterday was a rough day.

He uses the TL 866CS and works good for him, I did get mine to work when He sent them back to me and I pull the files off and I can do other chips also. But Im going to a different programmer when I...

For cold start up at 56 Deg C @ 20 Kpa I have to richin it up by 2 point. My question is.... is there another table I can use to do the samething? Initial startup AFR VS Coolant temp?

Just an...

Now what are fast Proms? I haven't converted pcm yet to 411. Still using OBD2 LT1 pcm.
using 28F512/28F010 150 chips. The 28F512's are getting harder to find.... Or getting spender
and if there is...

There should be a place in Norton where you can have the program excluded from nortons scan. There are some programs that it thinks that it is a virus by its code but just go in and add it to the...

Yeah that is quite confusing why yours did it and mine wouldn't till I was able to read the chips then I could write to them
once I pulled the files off the chips. But I think I'm going to invest...

Well problem solved... just dont think the programmer I have will read bin files that it doesnt take off the flash chips it self. Had someone burn my files onto a set of chips and I am able to read...

I was wondering about that. I sent them to someone also and it worked for him and was same programmer I believe. However that would explain way I was able to put an old chip that had data file on it...

I had an old chip and was able to read that and able to bin file on either chip and worked. Just when I tried to put GM calibration from couple sources that it errors out.

I have 97 OBD2 so don't know if it makes a difference. But the Eside (black connector side) on mine is the 28F512 and takes the 64k bin and on the T side (blue connector side) is a 28F010 150 and...

Anyone know the start and stop adress. I was just going off the software default of start 00000000 and stop of 0000FFFF

THanks

I have a socketed pcm so I can pull them out. And currently just cause it was cheap and supposedly worked good. I got a china made TL 866cs flash chip burner that supports N28F010/N28F512 chips.I did...

Just curious what Flash chip programmer do you guys recommend that does work for burning N28F512/N28F010 150 flash chips with GM Cal and tune Bin's. Its a 97 OBD2 LT1 I ordered a TL 866cs but that...

Hi everyone from SW Mn have 97 LT1 383 boost motor work in progress. And 04 Silverado SS that I haven't touched yet. Seen this site and a lot of good info and good people from what I've read.
...