Thanks! Ya I have the bluecat software and have been using it successfully. The issue seems to stem from a limitation of the "127.5mph" deal as bluecat tells me basically to enter 255mph for certain...

I'm looking for some advice on how to disable the TCC at say above 80% TPS... I see in the XDF I have there is a Torque Converter Release/Engage vs TPS table which seems to be triggered off MPH,...

Thanks for the reply's guys. I ended up taking the distro apart a few nights ago to investigate and see if there was a mechanical problem. Sure enough the nut on the lockout shaft backed out a bit...

Hey guys I have been struggling to get my TCC to lock up consistently and need your help. The issue is at steady speed once the TCC is set to engage in the tune, it locks, then unlocks sort of a...

There is no need to turn off the unused controls if you are planning on using it for standalone control over 4l80e. This is assuming you are unplugging the unused things like injectors, IAC, etc ......

Here's my additions:

-Added Table: Maximum TCC Duty Cycle Vs. Torque Pressure ( I set mine to 99% and min to 98% and it feels like another gear when it locks up)
-Added Error Codes: O2 sensor,...

Did these files ever make it "out in the wild" ? I would definitely be interested in taking a look at them....and maybe even contribute to them as well.. I've added a few extra parameters to the xdf.

Good info, thanks. May be a good call on the shift times. I recently changed mine and so far so good. My stock shift times were as high as 400ms and as low as 225ms. If I was to cut them in half, I'm...

I have been looking into doing the same thing, only on the ODB1 platform - the concepts are the same though. I found this thread that covers a lot of good info, and its specifically for HPTuners to...

I searched around trying to find the answer, but basically I am wanting to add "MAX TCC D.C. vs PSI" table from the BAMW hac into the existing $85 XDF...Easier said than done! haha
I was trying to...

EBL IS SOLD!! Thanks.

Up for sale is a great upgrade for the 454ss trucks / 1500's, thridgen camaros, and many other ECUs. This is a great mod if you have done comprehensive engine mods, but are...

I like where you are going with this, but did the 7060 come in any trucks that had 4wd? If it did, I would assume one pin would go to ground when you shifted the lever into 4lo....

The TBI and the O2 have been sold. I do still have the distro/efan/intake for sale though. PM me an offer if you are interested in everything.

Thanks again for the responses guys..

1BadAction- Where did you get the $D8 def for the 7060? If you could point me to it that would be awesome.

RobertISaar- Where is the code for the 7060...

What is the logic if I set the "Upshift RPM vs Shift" .. or is it used?

Basically I'm trying to figure out the best way to go about setting the shift points / rev limiter under the 4L80E section..

Thanks!!




That would be awesome if you could find this. Please let me know if you do.

Hey guys.. I have a few questions for you all regarding a 7427 swap w/a 4L80E. It is my understanding that I need to use $0E for the 4L80E. After that is where I get a bit foggy. So here is the back...

Hey guys, I have been lurking here for awhile and decided its time to post up.. :-) I have a 92 454ss truck w/the 4L80E. In its former life it had a supercharged 454 which was controlled by the EBL...

Hey guys.. Been lurking around here for awhile now. Lots of good info here. I recently upgraded the motor in my 1992 454SS and no longer have a use for the TBI and TBI related items. I'm presently...