Search:

Type: Posts; User: Kilroy

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    595

    Before you chase your tail guessing are there...

    Before you chase your tail guessing are there codes? Make sure pcm is sending shift commands to trans or at least the commands show up in realtime with a scanner.
  2. Replies
    6
    Views
    2,994

    I ran across this site for calculating flow rate...

    I ran across this site for calculating flow rate https://www.witchhunter.com/injectorcalc1.php
  3. Replies
    4
    Views
    2,334

    You say the lithium battery max charge is 16.8v...

    You say the lithium battery max charge is 16.8v but is the charge voltage that high? I don't know of any alternator charge system designed for over 14.8v. Anything over 15.0v is working in the realm...
  4. Replies
    34
    Views
    20,347

    1project2many brought out a thought about the...

    1project2many brought out a thought about the ignition module. When they fail it's a no start, cuts off, or erratic engine operation. So you go to the local el-cheapo parts house and buy a new one,...
  5. Replies
    34
    Views
    20,347

    Hello Old Fart here. Back in the day grew up...

    Hello Old Fart here. Back in the day grew up adjusting valves as part of Tune-ups. Before blameing anything else make sure the valves are correct. I suggest readjusting them here are a few hints....
  6. Replies
    68
    Views
    31,884

    Hello some thoughts here on your headache. The...

    Hello some thoughts here on your headache. The BLM and INT being way high obviously the ECM trying to correct for extreme lean. You could have a vacuum leak into crankcase area, #1 culprit would be...
  7. Replies
    6
    Views
    2,701

    Last night I disabled the three(3) BLM settings...

    Last night I disabled the three(3) BLM settings at 48EC now the engine idles in Cell #4 and seems to be a little smoother , drives the same otherwise so I'll see what happens.
  8. Replies
    6
    Views
    2,701

    Well I noticed something today while using ALDL...

    Well I noticed something today while using ALDL scan tool app with my phone today. When I shift from drive to park the BLM cell went from 17 to 19 instantaneous? Well thats curious? Dropped it right...
  9. Replies
    6
    Views
    2,701

    Thanks for the response. I did not word question...

    Thanks for the response. I did not word question well. I under stand that part but really looking for a diagram/illustration overlaying the BLM Cells over the VE table. It would be great help when...
  10. Replies
    6
    Views
    2,701

    Idle & Block Learn Cells

    Hello All, ...
  11. Thread: WOT Delay

    by Kilroy
    Replies
    3
    Views
    9,237

    Thanks Fast355, should of stated have BJYL bin,...

    Thanks Fast355, should of stated have BJYL bin, which it does have; TPS Threshold vs RPM for WOT and TPS Threshold vs RPM for WOT Fast. Both of these I lowered the TPS percent because of replacing...
  12. Thread: WOT Delay

    by Kilroy
    Replies
    3
    Views
    9,237

    WOT Delay

    Hello all, I've been absorbing knowledge here, very refreshing. I am working with a 1995 C1500, 5.7L, 4L60E, $OD and TunerCat Have two questions; ...
  13. Replies
    2
    Views
    16,099

    Thanks for post. This is so useful.

    Thanks for post. This is so useful.
  14. Replies
    28
    Views
    35,736

    Well read your whole thread and one thing comes...

    Well read your whole thread and one thing comes to mind working on these vehicles, IGNITION MODULE. It will screw up your timing, intermittently cut off ignition signal to PCM. You will be chasing...
Results 1 to 14 of 14