Bringing TBI and Multi Port Fuel Injection to a New Level.     EFI Conversions and Tuning! Seattle to Portland! E-mail Tuning Consultant!

Search:

Type: Posts; User: NISANDA

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. this is great! news

    this is great! news
  2. Replies
    1
    Views
    52

    You need the HP scanner for that, tunercat/jet...

    You need the HP scanner for that, tunercat/jet doesn't even have one.
  3. Have one but its in Cal. file.

    Have one but its in Cal. file.
  4. Replies
    1
    Views
    519

    This is the Bench harness i use to read ALL 99 to...

    This is the Bench harness i use to read ALL 99 to 06 PCMs (Gen 3), 4Cil (ecotec Blue/clear), V6 (Blue/clear) and all V8 (Blue/Red, Blue/Green).

    Connector one PCM C1 BLUE
    PIN#19 Power Ignition...
  5. I'm curious on how you plan to write the file?...

    I'm curious on how you plan to write the file? what are you using to tune? and the 411 pcm that you have its from what? sounds like you asking for the complete work not just a base file for your...
  6. Assuming the motor its a LM7 gen3, because if its...

    Assuming the motor its a LM7 gen3, because if its Gen4 2007 its would be a LY5, and your swapping so the best you can do to get a correct file its provide the injectors part number, to at least have...
  7. Just disable all the transmission DTCs, it will...

    Just disable all the transmission DTCs, it will run fine with you mechanical transmission and current motor.
  8. Have a cal file if you can work with it.

    Have a cal file if you can work with it.
  9. Replies
    6
    Views
    634

    Are all those files E67 controller only?, if yes...

    Are all those files E67 controller only?, if yes how to know what Serv. No.?
  10. Replies
    11
    Views
    845

    try this one, i made some changes maybe it will...

    try this one, i made some changes maybe it will start better also did a few tweaks for performance, still you need to tune for those injectors cuz 24lbs 3bar at 4 bar are more like 28lbs inj etc.
  11. Replies
    17
    Views
    1,797

    i run kind of the same setup for bench...

    i run kind of the same setup for bench read-writte, but only have check eng light, the obd2 port and the switch as led build in (ON on the ON position).
  12. Replies
    4
    Views
    815

    Great Info. Thanks for Sharing

    Great Info.

    Thanks for Sharing
  13. Replies
    17
    Views
    1,797

    Yes pretty much the same 

    Yes pretty much the same 
  14. Replies
    17
    Views
    1,797

    Yes, the pins are: Pin...

    Yes, the pins are:
    Pin 31 - Ign Voltage (Switch)
    Pin 32 - Battery Voltage (Constant)
    Pin 49 - Ground (Big Black-white wire)...
  15. Replies
    17
    Views
    1,797

    i can read t42 with out the e38 ECM they just...

    i can read t42 with out the e38 ECM they just dont show any vin number or vehicle info etc, but the file its readeble and writteable.
  16. Thread: 4L60 to 4L80

    by NISANDA
    Replies
    4
    Views
    623

    Grab any file with 4l80e and use import modules...

    Grab any file with 4l80e and use import modules option or segment swap (depending on software you are using) to tranfer the transmision part to your file.
  17. Just disconect the Maf and its should...

    Just disconect the Maf and its should automatically start using the Map.
  18. The file i send you, its has NO fuel adjusment at...

    The file i send you, its has NO fuel adjusment at all, just idle and timming you have to do the fuel, and it uses the same delphi maf same as a 5.3 LM7 Ls engine, calibrated diferently (Stock) for...
  19. Aksl, im NISANDA the one that send you the file,...

    Aksl, im NISANDA the one that send you the file, and its from a Silverado 2001 with the 5.7 vortec not a Express Van, in mexico there made 5.7s with the gen3 411 PCMs.

    The file i send you its all...
  20. So this Bin files can be used/supported with what...

    So this Bin files can be used/supported with what Programs?
  21. Replies
    4
    Views
    963

    DBC 5.3 Flex L59, 2002 Tahoe.

    DBC 5.3 Flex L59, 2002 Tahoe.
  22. Replies
    3
    Views
    1,140

    Nice project.:rockon:

    Nice project.:rockon:
  23. Replies
    12
    Views
    2,046

    Ahh! then i dont know if HPtuner will do those...

    Ahh! then i dont know if HPtuner will do those pcm's, Tunercats obd2 will but not for sale anymore, maybe efilive or jet dst.
  24. Replies
    12
    Views
    2,046

    i have tune those PCMs with HPtuners, S10 2.2 no...

    i have tune those PCMs with HPtuners, S10 2.2 no problem.
  25. Replies
    1
    Views
    2,162

    All Stock Files.

    All Stock Files.
Results 1 to 25 of 79
Page 1 of 4 1 2 3 4