Bringing TBI and Multi Port Fuel Injection to a New Level.     EFI Conversions and Tuning! Seattle to Portland! E-mail Tuning Consultant!

Search:

Type: Posts; User: notime2d8

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    10
    Views
    766

    yeah, with that Volvo setup the temp sensor...

    yeah, with that Volvo setup the temp sensor grounds the pin to the relays the same way the 7427 pcm would. So you can swap over one of the wires from the fan temp sensor to the pcm. For the cold...
  2. Replies
    10
    Views
    766

    I was never able to get the p/n working on a...

    I was never able to get the p/n working on a 7427. All of my swaps show in drive always except for the ones where i swapped in a 4l60e as well. And my truck with a maf swap and th350 it just idles at...
  3. Replies
    10
    Views
    899

    Did you adjust for the smaller 305 injectors?...

    Did you adjust for the smaller 305 injectors? Also the MAF code tended to run rich on the crank fueling....it may be even worse on the 305 running a 350 bin. And you have you MAP sensor hooked up and...
  4. Replies
    2
    Views
    471

    Post up your bin. You may need to...

    Post up your bin. You may need to increase/decrease fueling - or change your fueling corrections. When i had issues with idle it was my computer trying too hard to correct fueling in closed loop. I...
  5. Replies
    1
    Views
    444

    Can you compare it to a BJYM bin and see the...

    Can you compare it to a BJYM bin and see the differences? Most start off with that as a starter bin. Also do you have a VSS hooked up?
  6. Replies
    40
    Views
    11,852

    That sounds great. waiting to see how it runs....

    That sounds great. waiting to see how it runs. Are you going to get it dyno'd?
  7. Do you have a wideband o2? You might be running...

    Do you have a wideband o2? You might be running lean and have lean knock. More fuel would help it. But you'd need to know where to add it, only at WOT, or everywhere.
  8. Replies
    6
    Views
    858

    What is it doing? You should just have to change...

    What is it doing? You should just have to change the temp based scalers. Ones that increase timing for temp, AFR for temp, and engine RPM for temp.
  9. Hey, I would love to have it if i had the money....

    Hey, I would love to have it if i had the money. Just bad timing. I have alerts set for when they pop up on Ebay. It may sell well if you wait until around tax/bonus time or beginning of the year...
  10. Replies
    5
    Views
    760

    Does your Speed and MPH show correctly in the...

    Does your Speed and MPH show correctly in the data-log? And it's instant MPG, so it would be high when coasting and low at WOT. And is the IAT a wiring issue or it's not working on the PCM? I have...
  11. Replies
    5
    Views
    760

    Here you go. Let me know if it works for you. I...

    Here you go. Let me know if it works for you. I also added a MPG calculation as well. I only made 2 edits to the bin ALDL table And 4 edits to the ADX
  12. Replies
    4
    Views
    1,305

    Are you saying the Bluetooth one in the link is...

    Are you saying the Bluetooth one in the link is not what you want to do to get it wireless?

    There are instructions online on how to make a bluetooth ALDL adapter too with a bluetooth FTDI chip,...
  13. Replies
    14
    Views
    1,848

    Yeah a few bins have a PE delay for some seconds...

    Yeah a few bins have a PE delay for some seconds before it allows PE to come in.



    I honestly don't know about this one. Some argue both ways. I like to have it to bump timing up a few degrees...
  14. Replies
    4
    Views
    1,305

    The easiest is to go with a cable from the link...

    The easiest is to go with a cable from the link below or find one on ebay. They have Bluetooth and USB. I used a USB one to an android stick and from there to a 5 inch LCD screen.
    ...
  15. Replies
    14
    Views
    1,848

    Yeah, I would try removing the PE delays, and...

    Yeah, I would try removing the PE delays, and then lower when PE comes in...maybe 50-60% or 30 just to see what it does when it comes on. What was PE spark on the stock bin?
  16. Replies
    14
    Views
    1,848

    This should be your timing first, then PE timing,...

    This should be your timing first, then PE timing, and then your PE AFR. Do you have a backfire or sluggishness when you floor it? If not you should move to PE and Timing. Also making sure your trans...
  17. Replies
    14
    Views
    1,848

    AE is just used to get you into PE (Power...

    AE is just used to get you into PE (Power Enrichment). The AE TPS is for the quick stab of the throttle, That is too quick for the MAP sensor to pick up. Then the MAP AE comes in, then PE depending...
  18. Replies
    17
    Views
    2,903

    Fuel injection connection has one for $305 Link...

    Fuel injection connection has one for $305 Link
  19. You running mostly stock? Any issues to make you...

    You running mostly stock? Any issues to make you want to run richer? Need more info. There are quite a few spots to tweak for that.... you could want a richer idle, richer startup, richer closed...
  20. Replies
    12
    Views
    4,181

    Really wish i could see these pictures. I have a...

    Really wish i could see these pictures. I have a 02 Denali with a LQ4 and 4l60e sitting until i figure out what to do with it. Think the handling and center of gravity is too terrible for it in my...
  21. Replies
    8
    Views
    1,768

    Check your O2 settings. Your tune may be trying...

    Check your O2 settings. Your tune may be trying to correct the fuelling to quickly for your engine. Try lowering these if you have them. - PROPORTIONAL GAINS IF STABLE IDLE PRESENT/PROPORTIONAL GAINS...
  22. Replies
    73
    Views
    23,746

    You didn't put a caliper on those parts after...

    You didn't put a caliper on those parts after towing to make sure that they were within spec...not scientific :laugh:. Thanks for the info. I've never seen those upgrades for the T56.
  23. Thread: Bitchin' TBI

    by notime2d8
    Replies
    15
    Views
    2,813

    How come you didn't use the MAP vacuum port on...

    How come you didn't use the MAP vacuum port on the back of the throttle body? I think that's a ported vacuum spot you're using. And did you have the PCV hooked up when you cranked it?
  24. Replies
    8
    Views
    1,554

    Most TBI are set to start rich from cranking fuel...

    Most TBI are set to start rich from cranking fuel before leaning out.
  25. Replies
    9
    Views
    1,763

    Be sure to take pics and post up how things turn...

    Be sure to take pics and post up how things turn out. Which ECM/PCM will you be using?
Results 1 to 25 of 83
Page 1 of 4 1 2 3 4