That is what has happened to me. Paypal sent me a message to that effect.
Type: Posts; User: uncabob
That is what has happened to me. Paypal sent me a message to that effect.
Is anyone else having a problem with subscribing using PayPal?
Bob
When you replaced the ICM did you clean the interface and use a good die-electric paste?
You say your ECM is on the floor? Is it on dry carpet? Can the case be grounding out to the body...
Don't believe you should consider a one wire. Mad electric has some good tech info at " http://www.madelectrical.com/electrical-tech.shtml ".
Good luck!
Bob
Had heavy acceleration problem with one of my Explorers. Turned out to be the inline fuel filter. Could yours be that simple?
Bob
Welcome aboard.
Nothing wrong with crossfires, just the people working on them.
Mine is in a rat-rod p/u with a 122747 ECM. Are you going to upgrade to a modern faster ECM ?
Bob
WOW!
Welcome to the forum. Good info.
My build is a ratrod 49 Jimmie PU with a 84 corvette Xfire against aTH400.
20k original miles on the engine. Using original TBI.
Could not find an...
Some good info over at 3rdgen on spark latency for large cap HEI.
Bob
More info here
Thread: 1227747 to 16197427 Conversion PCM Swap with Wiring Pinout Directions!
D7
BobThread:
1227747 to 16197427 Conversion PCM Swap with Wiring Pinout Directions!
I had the same problem and also tried the RTV method. Messy!
Gave up and used old fashioned friction tape.
Wrapped the wires with a little more than enough to fill the gap then unwrapped a little...
You may want to look at the tuning section in the first sticky in this forum.
Bob
Hi Handyman: Think six is trying to lure you to the little box in the line under the red and yellow car.
Are you going tbi ? tpi? obdl? obdll?
You may want to look at the GM sub forum or the...
Mine appears to be different than your latency table. This one is for corvette with large cap.
The table you are using looks like my old one. My engine is basically a stock 84 corvette L83 5.7l....
Nope: Sounds like you should be good. Sorry if I side-tracked you.
Bob
Try searching for spark latency tables for large cap on Corvettes over on third.gen. IIRC it has to do with the larger radius
and the time it takes the rotor to move from point to point. It made...
Do you have the large cap HEI? If so you might check Spark latency table if it is included.
What ECM r u using? Welcome to the forum.
Bob
[QUOTE=Vetteflags;66131]Hello, not sure if this is the right place, but I didn't see OBDI tuning on the site just OBDII.
Check the sub-forum on Fuel injection writeups Articles and How to New...
Try post 2 attachment on this thread for color schematic. I used a combination of the diagrams there.
http://www.gearhead-efi.com/Fuel-Injection/showthread.php?304-1227747-ECM-Information-42
...
Thanks steveo I did not know that.
Bob
Oil pressure sensor disconnected or not working.
It should kick in when the oil pressure gets to a few pounds and bypasses the fuel pump relay.
Mine is on the back of the engine just below and to...
Welcome mo:
Whatcha workin on?
Define "stupid question"?
Dumb question, but have you verified fuel is actually getting up to the injectors?
Did the swap include the ECM?
Bob