Printable View
I noticed last night that at full throttle PE isnt kicking in. Closed loop and 14.7 Desired AFR. I looked in my scalars and I see PE Delay Time is 110 sec.
I assume that means I wont see PE mode for almost 2 minutes and this should be dropped to 0-1 seconds?
just found http://www.gearhead-efi.com/Fuel-Inj...PE-not-working
will be making adjustments accordingly and report back later
Yep, I remember that. It was back when I was still learning.
Set your PE delay to 0 and it should come on instantly now. You can also change at what throttle percent you want it to come on. I have mine set at 50%. So anytime I push the throttle past 50%, it goes into PE.
I have never tried it, but I would think it could be changed to whatever you want. Say like 75% or 90% if you wanted.