1 Attachment(s)
Still getting to know tunerpro. 1992 lt1 First data log
Hello everyone, I know anything I have to ask has probably been asked to death before so instead of asking a string of newb questions I figured I'd post up my data log to see if I could get any feedback on where I should start/focus. I've been scouring forums for a while now and still feel a bit lost. I know I'm probably running lean due to the 1.6 rockers/comp springs I've installed, that and my bpm is up at 9 for the idle and in the 30's for WOT. I also have an injector bank 2 error and an injector drive error that comes and goes at some point during the datalog. I also know the QDM circuit 3 error is due to tapping the ground for a fan switch (I plan on removing this now that I can adjust my fan temps, in fact so far that's the only thing I've modified on the bin file I got online for this ecu). I also have my ac compressor unplugged since it seized on me earlier the same day I did this datalog which is probably the cause for those erres, i think?. Only other mod I've done to this car is the throttle body coolant bypass. Oh yeah, it's a 1992 corvette auto 2.59 rear end. Hope this is enough info to get some input. One last note to mention is that I have yet to burn or install the new chip yet, this data log is still off the stock prom having already driven around for a solid half an hour in 100 degree heat. I started the log right before I pull out onto the street and Punched it through 1st gear, I then drove around and randomly punching it once to record a downshift acceleration.
Also, for some reason when I try to play this datalog on my desktop all the values in my item's list of tunerpro are set to N and I'm not sure why. I'm pretty sure I have the desktop tuner pro set up the same as the one on my laptop. that being said if this doesn't read for you I can try to upload it again directly from my laptop, But I'm thinking its the tuner pro on my desktop not the bin file thats the issue.