-
https://i.imgur.com/OC5JPNs.jpg
This is an onboard ALDL connector that I will hardwire into the datastream
https://i.imgur.com/rdaC7B1.jpg
FT232RL. I bought 3 of these IIRC, all of them were junk right out of the box except this one. Such is the case with cheap Chinese stuff sometimes.
https://i.imgur.com/6Vr0Hph.jpg
Stainless steel wire to hold the fuel level arm on where the plastic broke off.
https://i.imgur.com/wtvG4U2.jpg
4L80 shift kit instructions and kit contents
https://i.imgur.com/XEAGBvN.jpg
Building a E-fan mount
https://i.imgur.com/L1G6YGY.jpg
More mockup is under way.
https://i.imgur.com/y61FSGg.jpg
Harley turn signal stalks will be used to bolt the fan mount to the radiatior. Pieces of conduit are used for crush sleeves.
https://i.imgur.com/ZKNe2wb.jpg
Starting to make a mount for the trans cooler.
https://i.imgur.com/Dq7gsOv.jpg
4L80 ID tag. This one is an '01 unit.
https://i.imgur.com/iZ1zG6O.jpg
WB02 and trans temp mounted in a homemade holder. LED to indicate fan ON.
https://i.imgur.com/pjLHkfj.jpg
7427 PCM running the show.
https://i.imgur.com/deQhEqZ.jpg
Coming together.
https://i.imgur.com/lIDCpTg.jpg
I bought a Racetronix fuel pump hotwire kit and used it on my 3 bar SD turbo 6.0 truck. Their customer service is nonexistent, and their wiring is confusing as the color coding is not consistent. Also had a no start issue for several days because of a faulty connector that they supplied. SO..... I built my own hotwire kit for this one!
https://i.imgur.com/Fw7pHCl.jpg
Added a switched busbar that is hot on key on. Controlled by a relay.