Issues getting bin data to display correctly in TPRT

Hey guys,

Working on the XDF for my trans controller project and having a little issue displaying the data properly. Not sure(but likely is) if it's my fault in the code or how Ive set up the XDF but I have tried several ways. Anywho, when I open a table, say 1-2 shift MPH vs TPS%, instead of the value showing up on one line, 20% throttle = 18MPH, the "1" is on one line and the "8" are on the next line down. I have tried viewing as hex, integer, float, and ASCii and it always separates the value for some reason. Anyone have any ideas?

Thanks in advance,

Buddrow :mad1:

post the xdf lets have a look

tunerpro column sizing is wacky

I'll try later after I get home. THX

Buddrow

1 on one line and 8 on the next sounds like you have it set to display 8 bit values when it should be doing 16?

Robert,

When I change the xdf settings to 16 bit the cell is blank, same thing when I try 32 bit. The cell only shows the correct value when set as an ASCii character, although it staggers them as I stated earlier. Im lost at this point and this is the biggest hurdle I have left to finish this thing software-wise. I'm hesitant to post my source but will post the xdf.

Buddrow

you should post the bin associated with this xdf or theres' no way to figure this out.....

Quote:

---

Originally Posted by steveo

you should post the bin associated with this xdf or theres' no way to figure this out.....

---

You asked me to post the xdf. :innocent2:

Buddrow

it displays just fine for me when displaying random gibberish so i need to see your bin to find out why it's not working for you