Help! 90 Chevy Blazer starts runs dies?

Help! 90 Chevy Blazer starts runs dies? Has gas to throttle body and leaving the return line on the throttle body but the injectors slowly stop spraying after going from the start position to the run position? So soon after you let off the key from start position and the key goes to run position it dies just before you grab the shifter. watching the 2 two injectors and they spray really good while its running and then its like something tells the computer to stop spaying. Ive had the jumped to eliminate the possability of low voltage. I checked for Vacuum leaks and non were found. The check engine light isn't working at all either if that would tell us. check engine light worked yesturday. I think its pre injectors and post pump because it spays good when running. Any ideas?

Here's a pic of the fuel pump relay on the firewall...
Attachment 4368

The arrow is to the bypass connector. Connect this to 12V (fused w/ 1.5 amp) to bypass the relay and see if that fixes the problem. A new relay is around $15. Good luck!

That would not explain sudden loss of CEL?

Quote:

---

Originally Posted by ChrisBama

The check engine light isn't working at all either if that would tell us. check engine light worked yesturday. I think its pre injectors and post pump because it spays good when running. Any ideas?

---

Sounds like you blew a fuse, hopefully not a wire.

New Fuel pump and it runs good so far. The check engine light was working yesterday when I checked the fuel pressure so I think that was a fluke think? Thanks, Chris