I need help with a WB issue

I'm not sure what has changed or why but I have lost my WB in my data feed. I have swapped LC1's, swapped ECMs. downloaded the lastest S_AUJP files and nothing has helped. The WB is plugged into F14 just like it has been since I swapped over to the 7730. I can swap F14 and F15 pins and see the voltage for the WB on F15 but still nothing on F14 from the MAP(I thinks what F15 was). I tried the chip test and didn't get any voltage (assuming I was doing it correctly)so I swapped ECMs and still nothing.
ok, this is where it gets over my head. I can flash in Code $59 and the WB reads out just fine. I don't know how to move forward from here, any ideas?

The attached file are what I have been running. as well as the $59 used that actually worked. Current is for S_AUJP and the the Ostrich new Iroc was one of the files in the $59 folder

Thanks

I have been running Code 59 since I still haven't figured this out. I will continue to fight this until I get my WB data back. I'm also planning to try to use $8D with boost. I know others have made it work but it doesn't seem as if they shared their work. I can't say that I blame them since so many people use the work of others to make money.

I was never able to get F14 to work with S_AUJP, I had to use the alternat pin, which is A something, I want to say A6. The info on pins is in the documentation for S_AUJP.

Also check that that the pin select flag is correct for the pin your using.

F14 was working fine for me. I do recall struggling with it at first but can't remember what I ended up changing to get it working. My hard drive crashed and I had never backed up any of my files. I wasn't too concerned about TunerPro stuff since all I had to do was download the .XDF and .ADX files then download my tune from the Ostrich..... apparently I was wrong. It wasn't until recently when I went turbo that I realized I had a problem.

The pin select is correct and A3 is the other option. I'll figure it out. I have to, its driving me nuts.
Thanks