Anyone willing to program a few chips with stock bins for me?

My eprom programmer won't do (that I've found so far) the AN28F256-120 flash chips that my P66 ECM uses. I've socketed the one I bricked, and have located a few good pulls. Anyone here willing to flash them with the stock bins?

Hopefully I'll get the programmer working with these chips soon enough, I'm just looking for a quick solution to get the truck project rolling again.

EDIT: Also, will AN28F512-120 chips work? I have about a pint of those, pulled from old boards at work. Same board I pulled the sockets from, actually.

I tried the 512 in that PCM but they don`t work.
One more data pin is used. I didnt dig deeper to make them work, maybe board modification is needed.
If you can program 512 I doubt you can`t do 256 with the same programmer.
You can give it more tries.

Yeah, my programmer wont' do any of the 28F series chips, it's OOOOOLLLLLDDDDD. I built it from a kit in the mid 90's. I'll look around and see if I have a different one, I *might* have another.