-
1 Attachment(s)
Dom
Try this adx file and see if it works.
With ALDL Droid when you press connect ECU button it switches the 10k resistor and the data stream should start. The blue led will be flashing and then change to green yel/red.
If ALDL droid indicates no data stream check if the CEL light is flashing , probably look like it is full on. This will tell you if the data stream has at least started.
If this works your data may be a bit off due to this file, but we just want to see if the data stream starts.
If this doesn't work it may be another problem other than the ADX file or both.
Dom
sorry I put up the wrong file. I will change it and put the right one up in the morning.
MOC
-
1 Attachment(s)
Dom
try this one. Sorry about that busy day
MOC
-
I tried the 2nd file witch has the correct ECM number and I get a [connected waiting for ECM data] message. Never gets data.
-
Dom
Maybe back to basics
It's either the sensor state is not sending the message or the unit is not seeing the data.
Check pins A eth, B sensor, M 8192 data, G the blue tooth powers from this. This tag is fuel pump power
Is pin M actually in the right spot in the ALDL socket. When you get the message not seeing data is the CEL light flashing. If no the data has not started, if yes the data pin M is a problem.
I did read some where in the instructions from red devil that you may have to start the data by manually putting the 10k resistor in. This is a nuisance but if the data starts and works you know where you are. When working properly you connect the leds flash, press connect ECU the blue flashes then the other colors flash it connects and the data starts.
MOC
-
just tried and now not even Tuner Pro RT is not working.
-
Are you using the original ADX file for tuner pro?
-
Thank You MQQN28
I am giving up. I need to install an WB O2 sensor with gauge I can monitor that plus tune.
-
Dom
Sorry to hear that. I know mine was a battle at times but I got it, your initial query got me going again.
I'm at adjusting the ADX file at the moment but a little transmission problem has sidelined me. I will see the transmission man on the way home today.
When that problem is fixed I will be asking questions also.
MOC