Any chance I can just transfer my tables over when switching, or is it just asking for trouble, and I should just start from scratch again?
Printable View
Any chance I can just transfer my tables over when switching, or is it just asking for trouble, and I should just start from scratch again?
They won't fit exactly because the tables are differant. But yes use them it's a good start. Have to think about Idle and Off Idle tables as well.
That's what I was hoping. Thanks!
Ok. Everything is working, except for my bad knock sensor. Anyone know exactly what needs changed in the bin in order to disable the knock stuff? Only wanna do it until I change out the sensor for the newer one.
Most of the '7427 conversions I've done, I started with a base '7427 .bin file (ie 5.7 liter, 7.4 liter).
dave w
There's not some type of knock test like the 7747 had that needs to be set to "pass" so that timing isn't taken out? Also, if you don't run one, how do you go about tuning the spark tables?
I set Minimum Temperature for Knock Retard to maximum, to disable the "knock stuff".
dave w