-
under fan b calibration you should have 3 scalars labeled "Engine or Transmission Temperature" 1 through 3. set them all to "AE" as per the scalar descriptions:
Engine or Transmission Temperature 1
Location: 70CD
Set to A2 (00A2 coolant temperature) to use Fan B for cooling engine.
Set to AE (00AE transmission temperature) to use Fan B for cooling transmission.
Engine or Transmission Temperature 2
Location: 70E5
Set to A2 (00A2 coolant temperature) to use Fan B for cooling engine.
Set to AE (00AE transmission temperature) to use Fan B for cooling transmission.
Location: 710A
Set to A2 (00A2 coolant temperature) to use Fan B for cooling engine.
Set to AE (00AE transmission temperature) to use Fan B for cooling transmission.
-
I see my problem. I must of been using the older .xdf I found $0D Fan Control v100.zip and it had the scalars I needed. Thanks for yalls help.
-
new at tuning do i add to existing xdf or open fan xdf after and set ?
-
Easiest is to just open the xdf when you want to change the fan settings. Be careful to double and triple check the code you are adding to your bin for e-fans.
-
I loaded the XDF and set my setting it only put hex for those settings.I thought it was going to be that easy, then download a Bin from this topic if you go to page 7 i think you can download it that's how i figured that out it ain't that easy. I have learned a lot from this forum maybe I'll find a write up about writing hex editor If anyone knows somewhere i can learn more please point me in the right direction O by the way I think I got the fans figured out
-
How could i get the trans fan to control a heated o2 sencer, just a thought.