1227747 with Moates G2 Adapter installed and tested

1227747 with Moates G2 Adapter installed and tested, comes with 27Fs512 chip.

$110. PayPal Shipped

I always have a few of these available!

Do you have one of these on hand? Also do you have a (1227747) ASDX chip with highway lean cruise enabled?
Bob

Sorry these are all gone.

Although I could burn a ASDX with Lean Cruise chip for stock ECM.

What do you want for the chip? Do you think you could do a daughter board with the G2 adapter, I don't have any experience soldering so if I tried it would probably end up with a lot of junk parts.
Bob

I believe I have a '7747 or two, that I could modify.

IIRC Mark has the 24 pin EPROMs that will fit right in your holder and stock ECM though.

Let me know what you want for one and how I can pay you (PayPal?)

I'd see if Mark has the 24 pin EPROMs first, since that should be cheaper. It will be easier if it's just a couple small changes you want made, like a stock bin with lean cruise enabled.

Now if you plan to be making some changes in the future, and doing some of your own tuning, then the modified ECM will be a better idea.

As much as I could use the money right now, in school and the GF was just laid off her job yesterday, I'd rather see you get something cheaper if you can, as long as it will serve your purpose.

Actually I plan to experiment with burning my own but for the immediate future I'd like to have a stock chip with the lean cruise enabled. So I do want the G2 modified daughter board that I can use once I start experimenting. Does IROC Mark have another name because I was unable to locate him in a search.

At first I was thinking "Where did you get 'IROC Mike' from"...

Then I spotted it...

IIRC = If I Recall Correctly. ;)

EagleMark, the OP of this thread is who I was talking about. ;)

I'll go through my ECMs to be sure I have a '7747.

IROC Mark here! :laugh:

If your going to get a 7747 with the G2 then there's no reason to buy a 2732a/stock chip. A 27FS512 will plug in. Actually I've never tried but IIRC the 24 pin 2732a will plug into G2 adapter with the extra pins open... Either way if you want a chip give me a PM.