Cannot seem to get AE/PE right

Hi all,

95 Yukon 2wd with $0D. 350, AFR aluminum heads with 2.02 valves, XR258 Comp Cams cam, HEI, 46mm TBI on top of a 2" bore adapter to square bore dual plane intake. Shorty headers, dual electric fans. 255LPH fuel pump with CFM adjustable fuel pressure regulator. The regulator is cranked to 23psi at the moment. Fuel filter is a year old and has less than 10k on it.

I've been able to burn chips and tune it using Dave W's spreadsheet and TunerPro. It runs pretty well, except I cannot get it to stop leaning out and popping when I stomp on the gas. I've adjusted TPS and MAP AE values, PE, etc. but no change in the behavior. Once it recovers it has a ton of power, but that initial stomp damn near kills it.

Any ideas on what to adjust?

Thanks!
Mike

is your power enrichment delay truly zero?

I started with the stock bin (BJYL) settings. The ADX file is not quite clear on how any changes up or down affect the delay. Figured someone might have run into this.

Are you using an AFR Meter?

Maybe post a data log when the AE / PE is active.

Perhaps B3411 STOMP Compensation and B3412 STOMP Reduction.

To be clear, if you roll into the throttle it is OK?

Hiya,
Does this have stock injectors or aftermarket replacements? I've only seen this happen with aftermarket and high fuel pressure as they are then slow to respond. That big manifold and spacer will need quite a bit of change to AE.
Can you post your stock BJYL as well as your current tune. The latest file I have, in that series, is a BJYK. When things work right, you should be able to drown it at will, even with a supercharger.

Yes AEM 3110 tied into the ECM.

I think I got it figured out. I had to edit the VE table for low RPM high MAP and enrichen it. I also had to increase the AE vs TPS Difference table by 3x from stock.

Quote:

---

Originally Posted by In-Tech

Hiya,
Does this have stock injectors or aftermarket replacements? I've only seen this happen with aftermarket and high fuel pressure as they are then slow to respond. That big manifold and spacer will need quite a bit of change to AE.
Can you post your stock BJYL as well as your current tune. The latest file I have, in that series, is a BJYK. When things work right, you should be able to drown it at will, even with a supercharger.

---

Newish Delco stock injeectors. Not flow matched (I know, I know).

Quote:

---

Originally Posted by sntrym95

Yes AEM 3110 tied into the ECM.

---

Is the AEM 3110 0-5v output 10-20 AFR?

Quote:

---

Originally Posted by dave w

Is the AEM 3110 0-5v output 10-20 AFR?

---

Yes.

Quote:

---

Originally Posted by steveo

is your power enrichment delay truly zero?

---

OP didn't elaborate much if he truly understood what you were alluding to...take it for what it's worth...
Here's a good read... http://www.gearhead-efi.com/Fuel-Inj...PE-not-working

PE delay wasn't the issue. It was more AE and a lean condition when stomping the pedal. I provided the fix a few posts up.