I've trying to follow Eagle Mark's recommendations (thanks BTW), but can't seem to find a critical piece of information for setting BPW.
Where is the injector sizing post that lists the GM TBI injector numbers (listed at the top of the injector itself) that shows what flow rate they have?
found it here
http://www.diy-efi.org/gmecm/compone...injectors.html
To bad that one is still spreading bad information throughout the internet?
Try this:
http://www.gearhead-efi.com/Fuel-Inj...d-part-numbers
Mark,
This injector:
5235231 - Red / Blue - 80pph - 7.4L / 454 - 88-90 EDIT: Mr Injector flow rates are CC/Min=880 which is 83.81 LBS per HR
I'm curious to know what the hack says the pph is for this injector?
Like you pulled up my $85 and it said 75.5pph in the other thread?
80.50 lb/hr for the 80
75.55 lb/hr for the 74
61.22 lb/hr for the 61 that the Internet says is 55
I need to remove that Mr Injector data from that page. Although it is accurate it's not how GM did it and differences could be in fluid used.