-
The FT232RL works so it looks good, however the only way to find out if that board in particular works is to try it. The signaling needs to be 5v TTL, not 3.3. It isn't clear if the jumper selects the signaling voltage or an output voltage of the board.
-
i don't see where the jumper is intended to be placed to put it into 5V mode... i see a lot of 3.3v references, but no 5v.
i would ASSUME it would work, but there's only one way to know for certain.
-
I don't see the jumper either, I'm just going by the text.
-
what about this? i see a jumper to switch to 5v and i see the tx and rx ports
http://www.ebay.com/itm/FT232RL-USB2...item3f154a22b2
-
that one SHOULD work, has the RxD and TxD pins required along with the 5V switch.
however, shipping times are pretty blah.
-
right i know about shipping lol but its the quickest one i can find lol how fast did urs come
-
~2 weeks or so every time i've ordered them.
-
im guessing i should get the one u have since i know it works lol
-
Are you talking about the one that I sell?
http://reddevilriver.com/aldl.html
It is ready to go, plug and play. It does include the A-B resistor if needed. You can order it with either the 12 pin or 16 pin connector already on it. It ships from Wisconsin. It is more expensive however.
-
I wish lol cant afford it i mean the on from ebay
-
Well then for sure get the one that has the clear 3v-5v jumper on it. It should work.
I to also sell on ebay - Seller name RedDevilRiver also Phonedawgz
btw, yes it costs more on ebay - to pay the ebay fees.
-
ok so i got the chip how to i set it up so the computer reads it and so does tuner pro
-
http://www.ftdichip.com/Drivers/VCP.htm
grab the driver from here. install is pretty quick and simple.
then setup the correct COM port in tunerpro, load the right ADX and you're pretty much ready to go.
-
Wat can i use toflash it . I downloaded winflash but i cant find it
-
I downloaded the driver set to com3. tested it said found but at the bottem it says hardware not foound