1 Attachment(s)
trying to log in universal patcher
I have only one id loaded to start off simple.
it initializes the hardware says connected then i get this error
Unable to transmit, Error: 6C FE F0 20
Unable to set bus quiet
I searched on that error but didnt find much, any suggestions?
Thanks for all the help!!!!!!!
logging appears to be working.Some pid's don't seem to work, Ill have to determine if they are unsupported or something else.
This has been a deep dive into new territory, but I'm starting to get it.
2 questions though,
1) i remember the car used to shift from 1st to 2nd in second gear. Now the car is in 2nd gear from a stop, no 1st. I've tried changing max_gear_table in X_shift. I've lowered mph & rpm shift times in other tables but I haven't got back to 2nd gear starting in 1st then shifting to 2nd.
2) I found this table and apparently it enables or disables shift stabilization, but I don't find this tables in all bins.
Shift_Stab_Shift_Pattrn_Enble*01-
These flags will enable or disable ETC shift stabilization for the indicated shift pattern. , Units: T/F
The table has check boxes with T/F as the column header. I would have thought if checked meant True, since T is the first in T/F. But now I'm not sure. Same with max_gear says Maximum allowable gear based of range selector., Units: Gear is max gear low or high? I've tried both but doesn't seem to change as expected.
Every change i make I rename the file to have a restore point but I'm up to about 15 files.Getting confused. Sorry for the long post just trying to get a good understanding from forums and YouTube.