Again, you guys are AWESOME! Thank VERY much for the attached files. Exactly what was needed
Rolly
Printable View
Again, you guys are AWESOME! Thank VERY much for the attached files. Exactly what was needed
Rolly
Yes, mostly. You can view it in the $31 XDF that Dave W uploaded and in the other XDF's with the filename beginning Advanced..." With the .bin loaded look at Scalars -> Mask ID. There are some exceptions but if you stick to known files and confirm the correct mask each time, you should have no problems.Quote:
Is the mask ID available in the .bin even if the .bin and XDF files are not properly associated?
Hey Guys, need help in modifying XDF file for $31. Would like to expand columns from 11 to 16. See attached image file. Also made a test drive to record BLMs. See attached .xls file. Rick in some spots, lean in others. I can modify the VE fuel map to make these spots closer to 128. Any help with XDF file would be greatly appreciated.
Rolly
Hmmm....
You can tell the XDF that there are 16 columns and that will make TunerPro display 16 columns. But just like using the wrong definition, if there are only 11 columns in the .bin then changing the definition will only display other values incorrectly. It is possible to change the code in the chip so there are more values but it usually isn't a trivial task.
any updates on this one? have you managed to finish the tuning?
hello rsicard,
Did you finish the tune on the mpfi big block? Just wondering how it turned out.
Did you do the conversion on the ecm? Did you end up doing the jumper mod, or the sense resistor mod?
I too have a Edelbrock conversion, heads,cam,mpfi intake, chip, that was just bought and installed, as it came,back in 09....I ended up with it thru trade
it runs, ok I guess, but knowing how it should run, there is quite a bit left on the table.
I'm tackling the learning curve on some easier stuff first, before I take the plunge.
Just reading and gathering info.
Mike454