Hi all;
Didn't the SS use the LQ9 6.0L?
Mike
Printable View
Hi all;
Didn't the SS use the LQ9 6.0L?
Mike
6.0l
This one on first page: 05 Chevy 1500 4x4 MPV L59 12592618.bin (1.00 MB) says it's 4x4 but I just checked my buds 2004 SS 6.0L file and it has 4wd option enable too. It's a starting point :)
The L59 is a 5.3L right not the 6.0l I was looking for
Yep, you are correct, had to look it up. What about this one? 05 Chevy 1500 4X4 6.0L 12592618.bin (1.00 MB)
need a little help, and of course it on my personal vehicle, a 2005 yukon xl SLT with air suspension "auto ride"
the OS that came on the truck (not sure if the original OS, but the air works with it) is
OS 12606961
the reason i need to switch is that another person had a LQ4 in the truck that is no longer in the truck, so to put it back to a LM7 i am currently running a 2618 OS from a silverado.
the question is, does anyone know how to enable the air suspension in the 2618 OS or have a clean copy of the 12606961 OS?
thanks
JCC
edit -found out 9691 is the update OS for 2618, so ive grabbed an escalade os copy to attemp to get the autoride running
completely agree that the BCM is what eventually controls the air ride, but there is something in the PCM OS has something to do with it, i swapped over to the Escalade bin and segment swapped in the lm7 and 4l80e, and suddenly the air suspension works.
even during writing the PCM the cluster starting displaying messages about "service ride control" and "stability control".
so at some level the PCM OS has to call the BCM over the serial bus to tell it air ride is available.
but either way, it works now and felt great. right up until the tail shaft bushing ate the slip yoke and tossed another seal, lol. (i swapped my spare trans in and reused the other tail housing) just glad i caught it before it spun the bushing. always a new challenge with a frankenstien.
thank you for the reply
I have the OS 12606961. I understand this is the updated 12592618 5.3L. Could I use xdf of 618 for 6961? The only difference is two transmission changes from gm. The truck is a 2005 crew cab 5.3 w/ 4l60e. I would just like to remove vats, rear O2 sensors, and change differential so tach will be correct.
After reading pcm I received a reduced engine power message on dashboard this wouldn't have been the cause correct?
Any help would be appreciated
Yes I would have to wait till Thursday evening to post
I have the OS 12606961. I understand this is the updated 12592618 5.3L. Could I use xdf of 618 for 6961? The only difference is two transmission changes from gm. The truck is a 2005 crew cab 5.3 w/ 4l60e. I would just like to remove vats, rear O2 sensors, and change differential so tach will be correct.
Any help would be appreciated
i have a 1993 c1500 2wd and doing a ls swap . 2005 tahoe 5.3 460le doner. pcm is p59 os id 12592618 .this is the Compleat unit from the 2005 i have not changed anything. and i used the gas pedal as well is there a bin i can rewrite over to get me up and running ? any help is appreciated
Is the PCM serial number at 0x4000?
how do i download this to my computer so i can use it for my ecu