Interface does not support VPW 4X?
I am very new to this, so I apologize if this is a newbie issue, any ideas why I get this error along with the "Base address and size exceeds usable ram? I used Tunerpro and PCM Hammer 21. P01 2002 ECU. I have attached my Bin file and log for reference as well. This is a LS swap going into a jet boat.
[10:28:56:592] Validating 512k file.
[10:28:56:609] Start End Stored Needed Verdict Segment Name
[10:28:56:624] 00000 7FFFD EFCC EFCC Good Operating system
[10:28:56:639] 08002 13FFF BAA6 BAA6 Good Engine calibration
[10:28:56:655] 14002 16DFF A935 A935 Good Engine diagnostics.
[10:28:56:675] 16E02 1BDFF EAAB EAAB Good Transmission calibration
[10:28:56:689] 1BE02 1C7FF FDED FDED Good Transmission diagnostics
[10:28:56:705] 1C802 1E51F 9472 9472 Good Fuel system
[10:28:56:723] 1E522 1EE9F 4A68 4A68 Good System
[10:28:56:739] 1EEA2 1EF9F 22CB 22CB Good Speedometer
[10:28:56:758] Requesting operating system ID...
[10:28:56:904] PCM and file are both for the same Hardware P01_P59
[10:28:56:921] PCM and file are both operating system 12212156
[10:28:57:126] Unlock succeeded.
[10:28:57:182] This interface does not support VPW 4x
[10:28:57:196] Base address and size would exceed usable RAM.
[10:28:57:211] Failed to upload kernel to PCM
[10:28:57:225] Elapsed time 00:00:00.0827279
