Seems like the "hard" parts have been covered, the ECM modding, the memcal mod, software, etc, but I haven't seen any wiring diagrams!?
I've already swapped to a 7427 PCM, which runs fine with no issues with the factory TBI setup. Am I correct in assuming that each TBI injector goes to one bank of Saturated (14ish ohm) MPFI injectors and that's all the difference there is in injector wiring?
On the IAT, I do have a cast-in spot for it, since my intake doesn't have an EGR I'm re-purposing the EGR wiring as IAT sensor wiring, swap connector at the engine and swap the pins at the computer. Done.
I've had the intake kicking around for over a year, just now getting to it. Found some pretty slick throttle/cruise cable mounts that I think can be modded to work. Took a shot in the dark ordering an accelerator cable by looking at pictures and ended up nailing it first shot, a 84 crossfire corvette throttle cable is the correct length and fits perfectly at both the truck and intake end. Once I get the lower intake in the truck I can mock up all the vacuum lines and decide what boss I want to use for the brake booster. After that I can drop my freshly refurb'd Kehin 45lb'ers in and fire it up :wtg:
http://i.imgur.com/z85lHuu.jpg
