16197427 Stand-Alone 4L80E Controller

[dave w]

I'm looking for ideas or part numbers to add an additional TPS to a Holley Sniper Throttle Body..

Seems like a good plan using two TPS Sensors to isolate the Sniper TPS and 16197427 TPS 0 - 5 volts signals.

https://images.holley.com/550-511k_05.jpg

dave w

[1project2many]

What about a throttle pedal with a sensor attached? Maybe it's not too hard to add additional material for a cable to the 2001 Express van w/ 6.5 diesel pedal?

[dave w]

What about a throttle pedal with a sensor attached? Maybe it's not too hard to add additional material for a cable to the 2001 Express van w/ 6.5 diesel pedal?

That's an awesome idea! Thank you.

dave w

[brian617]

The 6.5 diesel APP pedal is doable welding the upper portion of the GAS pedal to the APP lever. The problem is the leverage ratio is wacky because the APP pedal and the GAS pedal pivot in different locations.

[c5wagner]

Isn't the sniper TPS 0-5V like the GM, couldn't you just tap into it?

[dave w]

Isn't the sniper TPS 0-5V like the GM, couldn't you just tap into it?

Yes, the Sniper TPS is 0 - 5V. Maybe yes / Maybe no on tapping into the Sniper 0 - 5v TPS. Maybe yes I would if it was my vehicle / maybe no for anyone else.:thumbsup:

dave w

[1project2many]

The 6.5 diesel APP pedal is doable welding the upper portion of the GAS pedal to the APP lever. The problem is the leverage ratio is wacky because the APP pedal and the GAS pedal pivot in different locations.

Does this result in unusual pedal feel? Or is there a challenge finding WOT?