Anyone able to help me troubleshoot my Dakota Digital VSS & SGI-5E (GM TBI, 16197427)

[rang-a-stang]

I am having trouble getting my VSS signal to my computer.

Hardware:
VSS: Dakota Digital SEN-01-4160, driven by my speedo cable
Translator: SGI-5E, Black VSS wire to Sensor ground, Grey to Signal, ground to body ground, 12v to pink/black, Output 5 to F12
Computer: 16197427, am on $OE but going to $OD,
Tuner: Laptop running TunerPro RT, Red Devil River Bluetooth ALDL

What I've done and indications:
Key on and SGI-5E powers on. I set it to L-L wtih no calibration changes. When I drive it, I see the LED flash on the display so it's getting a signal but TunerPro shows no speed. I verfied continuity across Output 5 to Pin F12.

I removed the VSS and spun it with a drill and watched it put out 2+volts A/C so the sensor seems to be working.

Is there a setting I am missing? Should be in Output 5 for 2000PPM for this computer, right?

[rang-a-stang]

Read through this thread:
http://www.gearhead-efi.com/Fuel-Injection/showthread.php?256-7427-install-first-impressions/page3
And see it says to:
"Speed sensor connects to pin F13, set "input not from drac" and ... two pulse vss"
I'll try this tonight or tomorrow.

[c5wagner]

Pin F13 is the one you want the 2000ppm connected to, the F12 is for transmission output speed which should be 128,000 pulse per mile if you have a 4l60e or 4l80e.

[rang-a-stang]

That was it! I had it on F12 AND had to change the "input not from drac". Now I have speed! Woo Hoo!