Log Transmission functions in TP?

[C2500]

Can this be done??
Thanks

[steveo]

if the data is available in the datastream on your particular vehicle, and your ADX is set up properly, yep

[C2500]

if the data is available in the datastream on your particular vehicle, and your ADX is set up properly, yep


Steveo, I’m guessing I can but I don”t know how to so I need some direction on this.
94 c2500 6395 ecm with a 4l60e. I want to delay the shifts and the 1/2 shift is sloppy.
The trans is all rebuilt and has the vette servo with all aftermarket parts..
Thanks

[steveo]

so that's $0E? there are transmission ADX files right in the 6395 info thread man. 0E is pretty well researched and documented

.. you have seen this thread, haven't you? http://www.gearhead-efi.com/Fuel-Injection/showthread.php?337-16196395-PCM-Information-OE

[C2500]

so that's $0E? there are transmission ADX files right in the 6395 info thread man. 0E is pretty well researched and documented

.. you have seen this thread, haven't you? http://www.gearhead-efi.com/Fuel-Injection/showthread.php?337-16196395-PCM-Information-OE

Sorry to bother you guys but I did not see that and I searched on here but I guess used the wrong words th search for what I need and I’m using $OD...

[myburb]

Being as you have a 60e you will need to use $OD and the trans files will let you data log trans and show the dash for trans. In your OD bin will be a number of changeable lines for the trans. That area is where you can change shift points, lock up speeds etc, you can also change pressures for shift. I would caution to be careful what you do in some of the settings. No willy nilly lets try it and see what happens. The result might be boom.

[sturgillbd]

Could also be $E6 mask...