wanderingturtle
07-19-2017, 04:00 AM
I had this posted in tunerpro talk but got no replies so I'm trying to post it here.
I'm trying to emulate and data log. I'm using Tunerpro RT with a Moates Autoprom on a chevy TBI with ECM 16167427
I am able to run the emulation and it says that it is emulating and the SES light is off, so I assume it is emulating.
I followed the steps in this thread to get it to connect for DA while emulating http://www.gearhead-efi.com/Fuel-Inj...-and-tuner-pro (http://www.gearhead-efi.com/Fuel-Injection/showthread.php?4423-simultaneous-emulating-and-datalogging-with-APU1-and-tuner-pro)
When I try to connect for Data Acquisition, I only get readings on the dash display for O2 sensor (http://shop.ebay.com/?_from=R40&_trksid=p5197.m570.l1313&_nkw=o2%20sensor) and TPS voltage. All the other readings are frozen. History table readings for BLM moves around to the cells for the correct MAP and RPM, but fills everything with 128.
Furthermore, when I disconnect the emulation, reboot tunerpro and try to data log using the pass through method (plug-in setting), I also get the frozen dash displays except for O2 sensor (http://shop.ebay.com/?_from=R40&_trksid=p5197.m570.l1313&_nkw=o2%20sensor) and TPS voltage. I can reset everything and reboot everything but I have to unplug the ECM and plug it back in order to be able to connect DA and have a fully functional display again.
What the heck is going on?!? I can't datalog and emulate like this! HAELP!!
I'm trying to emulate and data log. I'm using Tunerpro RT with a Moates Autoprom on a chevy TBI with ECM 16167427
I am able to run the emulation and it says that it is emulating and the SES light is off, so I assume it is emulating.
I followed the steps in this thread to get it to connect for DA while emulating http://www.gearhead-efi.com/Fuel-Inj...-and-tuner-pro (http://www.gearhead-efi.com/Fuel-Injection/showthread.php?4423-simultaneous-emulating-and-datalogging-with-APU1-and-tuner-pro)
When I try to connect for Data Acquisition, I only get readings on the dash display for O2 sensor (http://shop.ebay.com/?_from=R40&_trksid=p5197.m570.l1313&_nkw=o2%20sensor) and TPS voltage. All the other readings are frozen. History table readings for BLM moves around to the cells for the correct MAP and RPM, but fills everything with 128.
Furthermore, when I disconnect the emulation, reboot tunerpro and try to data log using the pass through method (plug-in setting), I also get the frozen dash displays except for O2 sensor (http://shop.ebay.com/?_from=R40&_trksid=p5197.m570.l1313&_nkw=o2%20sensor) and TPS voltage. I can reset everything and reboot everything but I have to unplug the ECM and plug it back in order to be able to connect DA and have a fully functional display again.
What the heck is going on?!? I can't datalog and emulate like this! HAELP!!