bdads
06-01-2016, 09:32 PM
looking for some advice,,,,
just installed my 30lb injectors on my 377 stroker ,,,
trying to find out what and where i have to change info in the bin file to adjust for them ,,, they are bosch dark orange color 4 hole injectors-- if that matters
im using the aujm bin fom the $6E section of the forums--- and could use other bins from there too if needed,,,
this thing runs way terrible since the injector change ...way rich --
plus i added a wide band o2 ,, wired it up to the original sensor lead also,,, used the 0. to 5. volt side to go to factory end
was running 305 factory injectors---- actually didnt seem to run too bad with the stock ones----
but early yet just broke this engine in ,, trying to get it dialed in now .... thanx guys
just installed my 30lb injectors on my 377 stroker ,,,
trying to find out what and where i have to change info in the bin file to adjust for them ,,, they are bosch dark orange color 4 hole injectors-- if that matters
im using the aujm bin fom the $6E section of the forums--- and could use other bins from there too if needed,,,
this thing runs way terrible since the injector change ...way rich --
plus i added a wide band o2 ,, wired it up to the original sensor lead also,,, used the 0. to 5. volt side to go to factory end
was running 305 factory injectors---- actually didnt seem to run too bad with the stock ones----
but early yet just broke this engine in ,, trying to get it dialed in now .... thanx guys