adding efan code

[jgarner]

so im adding an electric fan and would like to have my 7427 pcm control it. i found the table to enter in the hex editorbut not clear on what to do after that.

[sturgillbd]

What mask are you using? Is it $0D, $0E, $E6 or $31? I hand edited my bin and entered the code using the hex editor. It works great in $0D. After you enter the code, you have to wire in a fan relay. The PCM turns on the ground side of the coil for the fan relay to make the fan run with the temps you set in the code. Which fan code are you wanting to use?

[jgarner]

I'm using $0D mask and tps,soft start,transmission fan code I entered it into the hex editor and I understand I have to wire the ground for my fan relays to pin E3 but where do I adjust on off temps in tunerpro

[Nasty-Z]

I'm using $0D mask and tps,soft start,transmission fan code I entered it into the hex editor and I understand I have to wire the ground for my fan relays to pin E3 but where do I adjust on off temps in tunerpro

The $OD fan control XDF attached has all of the parameters you will need to make the fans do whatever you want . Simply select it as your XDF file.

TOM

[jgarner]

I think I have that xdf don't have my laptop with me if it is the same xdf when I opened it all I saw was the fan controls do I use it for the fans then switch xdf for everything else

[jgarner]

that was not the xdf I had I tried downloading the xdf you posted but I get a php file I am totally lost now

[sturgillbd]

Right click the link and save as....

[jgarner]

I tried that still getting a php file and windows wont open it

[Nasty-Z]

I tried that still getting a php file and windows wont open it

When you save the attachment it will name it as a .php file , after downloading or in the process of downloading simply change the file extension to .xdf and all will be fine .

Its a windows problem , Billy Gates out to get us all again ........

TOM

[jgarner]

changed the file extension now when I try to select that xdf tunerpro comes back with an invalid xdf

[sturgillbd]

What Operating System and browser are you using?

[jgarner]

Windows 7 and internet explorer

[sturgillbd]

I have no problem saving the link from Linux using Firefox or XP using IE. There is nothing wrong with the xdf file posted above by Nasty-Z.

[jgarner]

I'm sure there is nothing wrong with the xdf it's something I'm doing wrong now any bin or xdf I try to download from gearheadefi comes up a php file I'll have a friend who does IT work look at it tomorrow I have no idea what to do now

[fastacton]

Try Chrome or Firefox, I've given up on IE.

[jgarner]

ok I got the xdf downloaded with chrome but now tunerpro says its an invalid xdf

[sturgillbd]

PM me with your e-mail address and I will send it to you as an attachment.

[jgarner]

still didnt work im still getting invalid xdf from tunerpro im about ready to give up

[Six_Shooter]

I just downloaded the XDF that Nasty-z posted and it opens fine for me.

Where is it on your machine? Some people experience problems with placing XDFs or BINs in different folders, or separate drives that have different permissions, etc. Try placing the XDF in the Tuner Pro folder in the programs folder where other XDFs are stored. Make sure the extension is .xdf and not anything else.

Also that E-fan stuff should really be added to a more complete XDF. Switching between XDFs to change e-fan parameters can be annoying.

I know at one time I added at least some of the E-fan adjustments to an existing XDF when I added the code to the bin in my Grandfather's truck.