Looking for xdf info for Mefi 5

[Janky]

Hello,
I am sure this is being posted in the wrong area, but being my first I thought it should go here.

New to the site, have been looking through the forums as a guest for some time. I am actively looking for more information on xdf and bin files for a 2008 2.4l ecotec engine with a mefi 5 box.

more specifically, any data to support an issue with the controller cutting the rpm at 8000 rpm. In my .bin, I have the rev limiter set at 8800 and clamp limit set to 8500.

Our motor is mechanically built to handle the increase in RPM, so I am convinced it is an electronic problem.

Any info/advice/trolling would be apreciated.

Thanks,
- Bobby w/ Jet Motorsports

[highlander]

What are you using to tune this?

Can you post your bin file?

[Janky]

I am using TunerPro, and the MefiBurn module.

The XDF was given to us from a third party outside of MefiBurn and Bob. He was able to verify the issue and fix it, but stated there were "green tables I cannot see"

Is this something in the XDF that is preventing me from making changes? Is this a firmware issue with the controller as safety? Thanks in advance

[Skinny Pedal]

Whats the service/hardware # on the ECM? I ask that because not all the ECMs are true MEFI 5 and there are only a few that MEFIBurn can handle.

[04colyZQ8]

Whats the service/hardware # on the ECM? I ask that because not all the ECMs are true MEFI 5 and there are only a few that MEFIBurn can handle.

I’m looking to share mefi5 bin files, I have a ls7, I’d be interested in comparing other bins

[In-Tech]

COPO camaro with supercharger from about 7 years ago.

[04colyZQ8]

I'm looking for more xdfs and bin files for the mefi willing to trade