0411 PCM - Wide Band Output

[Scott68B]

I'm sure this has been asked/answered before but I can't seem to find it. I'm in the process of creating a wiring harness for my LS4. My 0411 came out of a 2001 S-10 4.3. I believe I have all the unused pins removed and all the needed pins added at this point. I almost forgot about my wide band and providing a pin for it so I can datalog with TunerPro. What pin is everyone using for their wide band signal?

Thanks!

Scott

[EagleMark]

The only ADX file I know of for TunerPRo uses the AVT-852 cable which has AD input ports installed so you wire the WB directly to it.

[Scott68B]

The only ADX file I know of for TunerPRo uses the AVT-852 cable which has AD input ports installed so you wire the WB directly to it.

Shit, I didn't realize that. I got an ADX off the pcmhacking site a few years ago along with a cheap ELM cable and was able to log my friends 96 LT4 Vette with Tunerpro 5. It was pretty simple but it wasn't configured to log a lot of information. I wonder if the ADX for the AVT-852 could be used to extend the one I used?

Thanks for the reply.

[EagleMark]

I think the adx files are different for ELM and AVT? Not sure.

Jayme has done some sweet work to the AVT cable ADX file. He keeps adding so the newest version can always be found in the top post here:
http://pcmhacking.net/forums/viewtopic.php?f=10&t=2314

[Scott68B]

Did some further searching and found the thread I was looking for. I think the last post in this thread gives some hope. :)

http://pcmhacking.net/forums/viewtopic.php?f=10&t=1320

[EagleMark]

That's the link I gave you above...