View Full Version : Placement of knock sensor
I have read about drilling and tapping the fuel pump block off plate on the small block chevy for a knock sensor. Would this be ok or should it be on the side of the block? Thanks
Nasty-Z
05-26-2011, 05:48 AM
I run mine in the coolant drain and have for years on my SBC's , they say you can drill and tap the F/P plate but I have never had the urge to mount it there myself.
TOM
EagleMark
05-27-2011, 06:33 PM
Knock sensor by GM design is intended to be in coolant!
Thanks guys for the replies.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.