Make your own carb to TBI adapter

[chevyguyase]

Make your own carb to tbi adapter for an inline 6. Use your gaskets as the templates. The upper and lower plates are 3/8" thick. The side pieces are 1/8" thick. cut a 1 3/4" pipe at 172 degrees, 1 7/8" long and then split the pipe and flip one side and you have the 2 sides, cut the triangle pieces to fill in the voids. It ends up at 2 1/4" tall. Thread the upper plate for the tbi unit. I used my drill press to keep my tap square to the plate. I used a regular 1 3/4" hole saw at slow speed with plenty of cutting fluid to cut the holes. Hope this helps.

[ony]

them are handy, if eagle mark was here he would say commiting adultry:innocent:

[chevyguyase]

Label me confused. I don't have the slightest clue of what your reply means

[ony]

eaglemark was a narriator in 2012,showed a lot of gearheads help for shore

[Six_Shooter]

eaglemark was a narriator in 2012,showed a lot of gearheads help for shore

He actually started this site. He's greatly missed.

[el Jefe]

Nice Work.

[chevyguyase]

el Jefe;96833]Nice Work.

Thank you, It's running great. I used the pcm, harness and hardware from an S10 4.3 engine

[WASyL]

nice work, but if you know how to weld why not open up that intake manifold to breath more air ?

[stackz]

Which inline is this for? Looks like it would fit my 59 235 intake. How much to make another? lol