How to modify 230 / 250 / 290 HEI distributor for use in a 235 https://www.trifive.com/threads/will-a-hei-distributor-for-a-250-work-in-a-235.53614/...

There were speed settings though, and those matched the tire type.

is your knock filter or module appropriate for a 454? aluminum heads are usually noisier so usually more false knock from valvetrain etc but engine...

Your EBL P4 is a little different than my Flash-II but, when I do the VE Learns I lock INT and BLM to 128. When VE Learn is enabled, it...

The XDF file is attached directly to the post I linked. It's the XDF that you'd want to edit the BIN. There's no reason to grab that modified EEHack...

Can't hear any knocking as well.:mad1:

I finally ended up going to a place that had a dyno and they got the ve tables to get the most horsepower. Now trying to get the spark tables right....

I tried downloading the file but its doesn't load as a valid ZIP file but a RAR file with a ZIP extension add on. When I remove the zip extension and...

If you turn off closed loop, it reverts to the open loop vs vac vs rpm table which is NOWHERE NEAR 14.7:1 in many places! So how is this the...

Oh wow, I had no idea. That's...kind of wild, actually. I might have to throw one in just for peace of mind, then. Thanks for the answer!

TBI unit is sold. 2 ecu’s still available. Both have the Moates flash chip conversion as well as the quick release adapter and a 27SF512 chip. ...

GM did not have a rev limiter on that application.

I believe I remember reading something about that being the stock settings in the docs for s_AUJP

The two EGR Enable Coolant Temp addresses are 2617 and 2618. You can find them using EEXTRA v0.001V6_3.xdf, which can be found here:...

Yes, some of the early stuff was in weird areas, IAT enable egr, watch for that. Either way, it's a one way, both have to pass enable check to...

I found the first 3 settings but not the 4th (EGR Enable Coolant Temps). I looked through all the tables and scalars. Using TunerPro with EEX.xdf. I...

EGR Min MAP > 103KPa EGR Enable Min RpM 6375RpM EGR Enable Max RpM 6350RpM EGR Enable Coolant Temps (both) > 116C No need to zero the EGR table...

I use WinFlash . . . I flash a "mule" PCM with the .cal file and read back a .bin file.

If I remember correctly, the 7 pin module and 4 pin module have different bolt patterns.

Nothing that I have seen unfortunately. But I was able to search tables and find their equivalents in Universal Patcher. You can also export a XDF...

FWIU, when you do the VE LEARN, it adjusts the VE table to dial it in. Running in CL, the VE table is used as a base and the INT/BLM adjust off it. ...