Activity Stream

I've always been challenged with tuning a TPI MAF system. I've had marginal success adjusting the MAF table to correct VE. I'd much rather tune a...

Johan Load the adx file into tuner pro using the Acquisition on the Menu. Open it with edit ADX the two little cog wheels icon. Go to dashboards...

I tried the file, it now saves/loads the dashboard but it does not read any values.. how do i remove the 2 empty dashboard from my original .adx...

Links: ...

Thank you, i will give it a try later this night

Just figured it out with your ADX file, there was indeed still a bug when creating dashboard page from ADX file when there is a single gauge on the...

K Will try ...thanx

My bad, I read it originally as you had a second ECM. I would still go over the harness, since it seems to be the last thing in question. I'm not...

tons of solder in a wiring harness can be problematic, especially if too much solder is applied to a particular joint. copper is flexible, solder...

Hello. I just downloaded the app from goggle play about 2weeks ago, has to be the latest one? can you load the files into aldldroid and see if you...

try this thread its got some info Thread: 16197427 PCM Information $0D its in the GM tbi tuning

Thank to all for thier replies.. I will continue looking for a solution. Truck is at shop and waiting to hear their opinion.? When I get it back, ...

I agree. I am thinking of a learned value determined at each startup based on whether or not knock is detected. This could be tested in another...

I installed a brand ne filter as well.. I was hoping it would be something simple but it is turning out to be a phantom

in service shop diagnosis, the technician will usually read the factory service manual. most service manuals have this diagnostic flow chart,...

Had heavy acceleration problem with one of my Explorers. Turned out to be the inline fuel filter. Could yours be that simple? Bob

Two years and 5500miles on new engine

I used a new distributor, cap, rotor, new wires, and plugs. Originally thought it was low fuel issue...new gas tank and fuel Sender as well.. I...

Easiest way is to swap the ECM for a known good one. You can also buy engine simulators to connect to the ECM to bench test it and observe the...

I really appreciate the theories. The vehicle stalled an died with modest throttle acceleration, that's why the restarts. The only log files I...

Pins on the old ECM look fine, but a new ECM fixed the Code 51 and it's back to running like it was. I haven't run into the sudden stall again,...

Thanks Steveo. I put the stock TB back on and the car straightened right up. Still have a split at idle, but it's only at +2/+11. I suspect I can get...

I think the only software that does the ODBII LT1 is the CATS OBDII tuner software. I think you can only get it from Jet or maybe Moates when you buy...

Understandable. Here are all the diffs - they're all relatively minor so it shouldn't be a problem applying them without using the patch binary. I...