Activity Stream

BJDR is the one I started out with on my recent 350 4L80 build. The Open Loop AFR table is stupid rich in that table. Try looking at one from a big...

You were exactly right, I had a crappy xdf. I got the advanced xdf now. Much better. I found the open loop afr vs temperature vs vacuum table and it...

I must be using a BJDR based bin then. I also tried BNKN at one time I think.

Fascinating. How does it stack up against the EBL at that point?

One option is to use a Moates.net Ostrich 2.0 (Chip Emulator) https://www.moates.net/ostrich-20-the-new-breed-p-169.html The emulator will make...

Welcome. Plenty of LS trucks have rusted out frames and bodys in Upstate NY, resulting in lots of good junkyard LS engines!

BJYL bin is $0D mask, not $0E. I had the exact same issue recently, I'll post my bin tomorrow for you to look at. The open loop afr table that...

" S.B.? is that a member on the forum? " a lot of them : somebody . lol

So went through the 8322 os in tunerpro compared to the 5074 holden. Its matches pretty close. the B.E. table wasn't populated, neither was the boost...

My bin is not a good reference. You should be looking at a clean gear-change only bin. Take a look here at the various stock bins with different...

Thank you for looking into this for me. S.B.? is that a member on the forum?

I sent you a private message. Would love to see if I can get my rig set up with this.

Well, with the 1x cam output, one could mount or buy a 24x crank reluctor while using a 0411 pcm. As years go by, and 2007-up pcms get hacked, one...

Glad you went through the math - Yes, I made an assumption of the injector firing once per two engine revolutions. I don't have the answer for TPI...

$0E is heavily documented and has a crap ton of parameters, in fact so many parameters you should be lost about which one to use rather than not...

yeah, sure is, but the new info is still relevant to the original discussion. I was more looking to develop a way to run coil near plug on a 60V6,...

Dave, You don't happen to have one of those systems for Vortec heads you are interested in selling do you? My state is starting to get picky about...

Blast from the past. Why not go to DIS on the 4.3? Why coil near plug?

That was exactly what I had in mind. Maybe. Maybe not. There's a reason the OEMs moved the reluctor wheels to the crank when OBD2 was...

:welcome: dave w

Dave W can make a 0411 PCM and harness work with this intake! I also have a lead on a Holley 670 cfm throttle body upgrade that fits right on this...

Hi Michael I'm using 808 ECU have collected a few Modified with USB comms board Aus All works fine using 12p code . Comparing timing...

It is for 1mb pcm by the year of it 2004. So it might be a newer version.

Sure that `s a big problem with the high res signal. Even the pcm have built in tolerance of +-2 degrees before it triggers a DTC. I have monitor...

this bin is odd i've always seen them 512KB Is something missing

But they work nice ;) Their chip sucks tho.