Activity Stream

4.9.1 is now on the download page and fixes a small bug i missed in the new VE analyzer

Thanks I appreciate that

this is great! news

You need the HP scanner for that, tunercat/jet doesn't even have one.

alright screw it i'll just release this new version so everyone can roll with it i'll throw the hammer down on the next version once i reassemble...

if patched it should work with engine not running however the error might be because there's no actual datastream definition for the e-side yet.

Not sure if it's my end or something else, but figure I'll point it out. In 4.84 (and possibly older versions, I haven't tested yet) with the latest...

The O2 sensor wires (harness side) both should present .45V on them when unplugged. Left/driver's side = Purple/White, Right/passenger side =...

i really like the idea of a nonvolatile recovery image we write first. i wonder if we can temporarily create a rebootable failsafe loop with an exit...

Nice ideas Steveo. The best improvement will be to keep the flash routine indefinite in the pcm and continue from there with new aldl cable and PC...

On the right and left side disconnect all AIR pipes that comes out from the exhaust header and plug the holes on the header. It is very likely the...

I scored a stock bin for you. It is also set for manual now. Check your gears, this one is for 2.73 final ratio. The checkbox is located in the...

@#$&%. ......I’m absolutely lost . He did exactly as noted. Unplugged both O2 sensors, disconnected the battery. Let the car sit over night. Hooked...

I thought it was odd when I saw it. 4.3 or EEX was the first thing that came to mind but the VIN pulls up a 94 Camaro "set it to manual with the...

Tested 4.84 on the way to work. Fixed the speedlog bugs from the previous version, both on the dash and in the analyzer! Honestly it looks great....

Thanks, I will check the schematics if pressure control solenoid section is repairable by me. If not, it might be still good enough PCM to run TH700.

i can work on copy paste tables for next version knock warning has been broken for a long time dual wideband display could happen but low...

Evening Stevo Just downloaded v4.84 On the front page it shows v4.80 (Pre-release) Also, I guess it's a QT issue, Is it possible to be able...

Wow! That opens up some possibilities! Thank you!

I think & will confirm when I get a chance, the area just above ram connects to the injector driver circuit (?) Have you checked to see if the...

I have done some looking at the registers the code uses. This is NOT finished work but rather a snap of where I am on this project... ...

Thank you... this is a good thread for me. I have some documents specific to the '97 lt1 malf codes I will post. -Tom

i've come to a decision, no more new features in this beta. there are too many important improvements in here to wait for release any longer, such...

Thanks, that helps. About to post some analysis of the timer chip... switching threads. -Tom

here's a new beta. the analyzer ui is getting better. i've matched the ve analyzer to the actual ve table size (a common request) which will make...

:welcome: Many options for EFI conversions with either Aftermarket or Factory systems. The Factory 16197427 computer could be a "one size fits...

COPO camaro with supercharger from about 7 years ago.

Thanks, that is what I want to focus on. He was going to unplug the O2 sensors tonight and unhook the battery. Then hook the battery only back up in...

force open loop and if it runs 1000x better at least you’ll know what to focus on....