Thanks dave, I was just looking for a starting point. Figure I'll be datalogging and tuning once I get it up and running well enough to hit the road....

BLM is indicating rich (taking away fuel). IAC says throttle sludged up (too many counts w/TPS being correct). O2 could be lying, unplug all oxygen...

Often the injector flow rate is tweaked in the PROM Chip. Injector flow rate setting in the PROM Chip is often a "course tune" setting. Data log...

I've set that to 80lbs.

TunerPro RT, $0D definition. FPR cover? Are you talking about the spring cup? That is next on the list of things to do. I already know that 14psi...

$0D uses the actual injector flow in the calibration. It's located at 0x4D88 and 0x4D89. What are you using for tuning package? What definition...

I vaguely remember that discussion as I was subscribed to that mailing list in the late '90s. I seem to recall wiring 1-4-6-7 on one driver and...

Maybe I'm just totally confused now. I purchased the ebl flash ll for my 4.3 v6 TBI turbo project and it worked great! But I'm upgrading to a marine...

Ok folks, it's all under the hood now and will be finishing the exhaust tomorrow morning. I did fire it with open headers and it ran decent for a few...

They did. I believe I have one of their calibrations from a 454 swap. They didn't even change the injector firing strategy. This was talked about...

So I went ahead and bought that cable and get the same behavior. But as it turns out if I had just gone to data lists I would have seen some data...

:welcome:

here is a new rock auto discount code 292889595260676846 exp, march 7 2025

96 is using aldl protocol for body modules, only pcm is vpw. You should be able to read the bcm content using the mode 2 commands. It is built in...

Any ideas here?

Thank you, Fast355, I appreciate the time that you give to me and others on the forum.

618 os, L31 5.7L, 4L80E, 4x4 and Van system segment. The fuel volume and resistance settings and gauge output are the main things to look at. You may...

I'm thinking the same thing. I'm horrible with anything electrical unless I have a step by step guide so this EBL has been a blessing with my turbo...

I’m wondering why not try using the EBL with 6 saturated (port) injectors? Edelbrock used to sell a MPFI conversion system (part # 3505 for...

Thank you Fast355. I'll try it this weekend. This is for P59 618 OS?

This is spot on for a K1500 extended cab tank, should be 25 gallons.

That cam is pretty much the same as a stock TPI. In reality, the factory AUJP bin should work just fine I would think. I'm wondering if...

ULTM8Z I have read a lot of your information on AE tuning. It is a lot to grasp and I am more than willing to to upload a datalog and bin. After...

The 749 is not so different from the 7427 except that it cannot control an electronic transmission. The PFI memcal modification could be considered...