That is not what I asked.

I have been looking around and it looks like there are a lot of bottom feed injectors that are for 2.5's. I have 1 that was used on 2.5, 2.2 and 2.0...

ok that would be great i would appreciate it Thank You

Also does anyone know anything about the TCM used in the 93-95 jeep grand Cherokee? These were for a 42re. Reported to be the same electronically as...

Ok. Thanks for reply. How do I run a debug log? And is there a list of uses or just start. Pulling in order? Also how would I tell if it’s a...

That sounds good, what psi does those run at and where should I get them. Is there a good place to purchases them and should I try to get new ones....

There's a parameter in there "Speed pulses per driveshaft revolution" I'm wondering if this is what you want to change. Maybe it's as simple as...

Some debug log will help figure problems, looks like some module don`t stay quiet, Try pulling some fuses. You may have a ground issues too, that...

Hi. Not sure if I attached this correctly. The tires are 255 40r 18 Nitto Invo.

Incase anyone needs to know it took me a while to find this, but here is where the pinout is for the TBI hall effect distributor ...

I know it's been a while, all a year since I started this thread. I have acquired a distributor for a 79 New Yorker with a 318. It has a VR pickup...

Attach your bin file to a post here. Also what is the stock tire size on your Camaro?

The injector size calculator believes a pair of 52 lb/hr injectors will support 220 hp. It looks like the 2.5L/2.2L TBI injector is rated for 56...

The stock 280z had 178 and with the mods on my car it should be about 200, some say with the mods I have it could be as much as 220 but I don't think...

Perhaps these screen captures will help?

Most TBI applications operate within a range of 9-13 psi fuel pressure. GM did alter operating pressure for some applications. The 91-94 Saturn 1.9...

The 10K resistor is not required with $4F. The attached $4F data log was recorded with a cable from aldlcable.com:...

Yes, there is. Go to parameter finder and type in "fans". There's also a selection for what type of fans: G1203. Yours is probably set to no fans.

I don't know how y'all get anything done with the onslaught of crappy imported parts. Two totally junk oil pressure senders, third time was the...

I have tried both. The aldl is on Com 3. I am receiving data but it is not a very good stream. Receives useable data maybe every 10-40 seconds, zero...

Where should I start? I found this 5277 injector that might be in-between the 2 I have. This one came off of a 90LLV 2.5, 90 Beretta 2.2 and 88...

https://www.gearhead-efi.com/Fuel-Injection/showthread.php?521-1228747-ECM-Information-4F shows 2 different .adx files. Which .adx file are you...

Hello, I don't remember ever seeing ratings for those injectors. I'm not aware of a tuning definition to allow one to see the BPW constant,...

Maybe the best approach is to start from scratch? Get a pair of injectors from a known application and enter the correct injector values into the...

I don't understand why AFI didn't have me turn the pressure up on the smaller injector to give it more fuel, my fuel pump and regulator are able to...